Forum-Gallery-Shop-Sponsors

« Advertise on Freel2.com

Home > Maintenance & Modifications > Nav system info needed
Post Reply  Down to end
Page 6 of 12 <123 ... 567 ... 101112>
Print this entire topic · 
tuwana



Member Since: 15 Feb 2010
Location: Istanbul
Posts: 37

Turkey 2008 Freelander 2 TD4 HSE Auto Stornoway Grey

Dropbear wrote:

I wasn't upset that I didn't recieve the reverse camera as it meant drilling a hole in the rear bumper, not something I could do. I was looking at purchasing a camera that fits on the number plate. these seem cheap from Ebay.


You are right,I don't want to drill the bumper,for that reason they make me a inner camera at tail gate windows,ı will send you a photos soon.
I sent to photos ,you may see them in my gallery


Last edited by tuwana on 3rd Mar 2010 10:08 am. Edited 2 times in total

Post #60806 22nd Feb 2010 9:10 am
View user's profile Send private message View poster's gallery Reply with quote
alex_pescaru



Member Since: 12 Mar 2009
Location: RO
Posts: 4642

Dropbear wrote:
Alex, What I meant regards not saving locations was it didn't save favorites or even by home location. Surely this isn't normal for the Sygic S/W. Other system settings like 2D or 3D view didn't save either!

This is quite strange, because my unit saves Home location (in fact I am using it quite often) and favorites...
Also 2D and 3D information.
Try something: after setting the parameters as you like, get out of the program (Settings -> Exit) and let the program to reload. For sure it will save the configuration. I am doing this way to be sure.
So, after each major change in settings, exit the program to be sure it saves the settings. Again, it is a software "problem", if you can name it that way.

Post #60809 22nd Feb 2010 9:35 am
View user's profile Send private message View poster's gallery Reply with quote
vibecy



Member Since: 29 Oct 2009
Location: Nicosia
Posts: 49

Cyprus 

alex_pescaru wrote:
vibecy wrote:
Do you mind elaborating a bit more on this part?

Here is the documentation that I've got from the manufacturer:
https://www.freel2.com/gallery/albums/user..._guide.pdf

vibecy wrote:
Do you mean connect the handbrake wire on the UNIT to Earth/GND? Where exactly should it be grounded? (I have no clue as far as electronics go!)

No, I mean if you want normal unit function, then connect unit's handbrake cable to car's handbrake cable.
As a workaround, connect unit's handbrake cable directly to earth/gnd. A GND point could be even the GND connection of the power cable. Read below.

vibecy wrote:
It will be much more useful to me to be able to choose what I see on my unit screen (divx or sygic, depending on the situation).

If you not connect the unit's handbrake cable to car's handbrake cable, the unit will consider as if the handbrake is released so it will automatically launch the navi program and you will not be able to see video or listen to music.
Multimedia could be experienced only if you connect the unit's handbrake cable to car's handbrake cable.
Or, as a workaround for this, you will permanently connect the unit's handbrake cable to earth/gnd and then the unit will believe that the handbrake is permanently ON and you will have full access to the unit options, evidently without the option of automatically launching the navi program when you release the handbrake.
But, in the long run, it is a little bit dangerous this way because the unit is made like this for security reasons, meaning that you can see video only when stationary with handbrake ON. It doesn't allow you to be distracted by the video when driving.


Thanks again for all the info alex, really appreciated. I will go with the not-so-safe option though Very Happy

As soon as the dealer is ready for installation, I will try to get pics and videos for those who are interested.

R.

Post #60810 22nd Feb 2010 9:36 am
View user's profile Send private message View poster's gallery Reply with quote
mickhep



Member Since: 03 May 2009
Location: uk
Posts: 22

Hi Lar
How have you fixed the C725 to the back of the dash..?
I am looking at the mio V735 here in the UK,so I would be interested in the fixing method used.
cheers
Mick Commercial S,with climate and leather retrim

Post #60986 23rd Feb 2010 4:38 pm
View user's profile Send private message View poster's gallery Reply with quote
lar



Member Since: 29 Nov 2009
Location: Yaroslavl
Posts: 251

Russia 2008 Freelander 2 TD4 SE Auto Stornoway Grey

I didn't make photos. However I have photos of Comstorm's installation in Freelander. I have fixed C725 with the such way. I think you will understand all with these picters.

Click image to enlarge

Click image to enlarge

Click image to enlarge

Click image to enlarge

Click image to enlarge

PS Comstorm 7 is the device based on MIPS processor. 
Freelander II 2,2 TD SE Stornoway Grey

Sorry for my wry English. I began to study it recently.
I'll be thankful for your corrections of my mistakes


Last edited by lar on 23rd Feb 2010 6:33 pm. Edited 2 times in total

Post #61003 23rd Feb 2010 5:53 pm
View user's profile Send private message View poster's gallery Reply with quote
mickhep



Member Since: 03 May 2009
Location: uk
Posts: 22

Hi Lars
Thanks for the quick response,the straps look like a good way of fixing it, are they available off the shelf..?
ie internet or did you make them yourself.?
Also the 735 measures approx 14mm longer than the 725 so I will have to check wether it will fit ok without major surgery to either the unit or the dash.
Thanks again
Mick Commercial S,with climate and leather retrim

Post #61004 23rd Feb 2010 6:04 pm
View user's profile Send private message View poster's gallery Reply with quote
lar



Member Since: 29 Nov 2009
Location: Yaroslavl
Posts: 251

Russia 2008 Freelander 2 TD4 SE Auto Stornoway Grey

Plastic 5-inch tube's fittings was put to use for this installation. You can see it on first picture

mickhep wrote:

Also the 735 measures approx 14mm longer than the 725 so I will have to check wether it will fit ok without major surgery to either the unit or the dash.

C725 is fited on the nose. Maximum sizes for installation without major surgery are approximately 190x120 mm 
Freelander II 2,2 TD SE Stornoway Grey

Sorry for my wry English. I began to study it recently.
I'll be thankful for your corrections of my mistakes

Post #61008 23rd Feb 2010 6:32 pm
View user's profile Send private message View poster's gallery Reply with quote
mickhep



Member Since: 03 May 2009
Location: uk
Posts: 22

"C725 is fited on the nose. Maximum sizes for installation without major surgery are approximately 190x120 mm"
The 735 measures 196mm x 105mm with a curved edge to it. Crying or Very sad Crying or Very sad
I might have to get one to try it..? what would be involved on the width to get it to fit..?

Thanks
Mick

http://eu.mio.com/en_gb/navman-spirit-v735-tv_specifications.htm Commercial S,with climate and leather retrim

Post #61023 23rd Feb 2010 7:39 pm
View user's profile Send private message View poster's gallery Reply with quote
RobbieHLM



Member Since: 23 Feb 2010
Location: Haarlem
Posts: 3

Netherlands 2009 Freelander 2 TD4_e S Manual Biscay Blue

Hi Lar,
I noticed your project and would like to do the same.
Purchased a 7" portable navigation system (like your mio) and would like to install it this weekend.

However I don't understand how you are able to turn the device off and on?

It is my understanding that you did some scripting. Could you be so kind to tell me what to do?

Kind regards,

Robbert

Post #61045 23rd Feb 2010 8:57 pm
View user's profile Send private message View poster's gallery Reply with quote
tuwana



Member Since: 15 Feb 2010
Location: Istanbul
Posts: 37

Turkey 2008 Freelander 2 TD4 HSE Auto Stornoway Grey

RobbieHLM wrote:
Hi Lar,
I noticed your project However I don't understand how you are able to turn the device off and on?


Really Lar I don't understand too,How did you do?How did you load unload the Sd card from the unıt? Rolling Eyes

Post #61077 24th Feb 2010 7:59 am
View user's profile Send private message View poster's gallery Reply with quote
alex_pescaru



Member Since: 12 Mar 2009
Location: RO
Posts: 4642

He uses the USB connections of the unit for updating maps and software.
See his message from December 2nd, in this thread.
http://www.freel2.com/forum/viewtopic.php?p=51402#51402

PS: I hope that I didn't upset you Lar, because I've answered in your place. Thumbs Up

Post #61088 24th Feb 2010 9:26 am
View user's profile Send private message View poster's gallery Reply with quote
tuwana



Member Since: 15 Feb 2010
Location: Istanbul
Posts: 37

Turkey 2008 Freelander 2 TD4 HSE Auto Stornoway Grey

alex_pescaru wrote:
He uses the USB connections of the unit for updating maps and software.
See his message from December 2nd, in this thread.
http://www.freel2.com/forum/viewtopic.php?p=51402#51402


Ok how does he shut down becaues the power button at the top of the umıt(in dash now),İs there any off button on the program on screen? Sad

Post #61118 24th Feb 2010 12:01 pm
View user's profile Send private message View poster's gallery Reply with quote
RobbieHLM



Member Since: 23 Feb 2010
Location: Haarlem
Posts: 3

Netherlands 2009 Freelander 2 TD4_e S Manual Biscay Blue

Hi Alex,
Thank you very much for your prompt reply.

The updating of the maps etc is clear to me. However since the power buttons are hidden, one would need some script in order to turn the device on and off.
I was looking for some scripts where de device will react on AC power (eg startup at AC power and hibrenate when AC power is off).
Since I am not a programmer I don't understand these scripts and it seems quite complicated.

I am very curious how Lar solved this challenge.

Kind regards,

Robbert

Post #61141 24th Feb 2010 4:08 pm
View user's profile Send private message View poster's gallery Reply with quote
alex_pescaru



Member Since: 12 Mar 2009
Location: RO
Posts: 4642

RobbieHLM wrote:
I was looking for some scripts where de device will react on AC power (eg startup at AC power and hibrenate when AC power is off).
I am very curious how Lar solved this challenge.


I am curious too, because before buying the current navi unit I was looking for an integration of a similar device.
I believe that Lar has used MortScript but maybe he will share in more detail some of his experiences.

Post #61153 24th Feb 2010 5:10 pm
View user's profile Send private message View poster's gallery Reply with quote
lar



Member Since: 29 Nov 2009
Location: Yaroslavl
Posts: 251

Russia 2008 Freelander 2 TD4 SE Auto Stornoway Grey

Sorry, guys
I didn't have a time for a reply. I'll answer to all questions. 
Freelander II 2,2 TD SE Stornoway Grey

Sorry for my wry English. I began to study it recently.
I'll be thankful for your corrections of my mistakes

Post #61156 24th Feb 2010 5:41 pm
View user's profile Send private message View poster's gallery Reply with quote
Post Reply  Back to top
Page 6 of 12 <123 ... 567 ... 101112>
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
Freel2.com RSS Feed - All Forums


Switch to Mobile site