Hi All my dad has a 2009 freelander 2 td4 (2.2d) and on his way home today he has EML come on and called AA out they have attended and pulled a few fault codes out.

What do people think it could be i have done a bit of googling but its all conflicting information

Any help would be great

Thank You

Quote:

Patrol found the following fault code/s:System : Engine control - 57Y / Diesel EDC 16CP39U2101 - Control unit configuration. Error Message : Malfunction.P1603 - EEPROM error. Error Message : Malfunction.P0380 - Glow plug/heater circuit (A). Error Message : Malfunction.EML on, no loss of power. Fault codes stored as above, faults will not erase

First thing I'd do is check the battery and the earth connection. FL2 are prone to throwing up errors if battery connections corroded. Some people add an extra earth cable for this very reason.

Assuming the car is actually running OK (you didnt say that it wasn't) then I'd then clear all the codes with my Torque Pro / OBD dongle and wait to see what happens next. Jules

car runs spot on no loss in performance, no smoke, feels just like it did before

AA tried to clear with Autocom but codes would not clear.

Ill check battery tomorrow to see if its corroded

some times clearing codes in basic "eobd" ,and not specific model works.

hi all,

had glow plugs replaced and faults cleared but eml still on

Now when you clear the codes do they return still after doing the glow plugs ? FL2 MY10 TD4 GS traded in at 2 years
FL2 MY13 TD4 GS Current

Yea faults clear but come straight back on

You need to get the codes read to 6 figures. FL2 MY10 TD4 GS traded in at 2 years
FL2 MY13 TD4 GS Current

Been in touch with garage they sent codes over

U2102-00 control module configuration incompatible
P1603-00 electronically erasable programmable read only memory malfunction

They are saying this is reason light is on

I was expecting more than 00 but thats what you need to deal with whatever they mean. I think a list of codes was published once on here. FL2 MY10 TD4 GS traded in at 2 years
FL2 MY13 TD4 GS Current

Hi

Both these codes are associated with the ECM, have any of the other modules in the car been scanned? Eg with a Landy specific code reader as opposed to OBD2? Such as the PCM, BCM modules etc.

One possibilty may be communication between the cluster unit and the ECM over CAN network. Since without one or more EPROMs in the ECM been operational the car would most likely not start I would be looking at other connected modules on the bus which could be causing issues with the ECM. Especially modules which may send data to the ECM to be stored on a temporary basis.

Ta

The problem is in the files updated from SDD I have the same problem.