Using one shot close on rear window , window closes then immediately re-opens to 2/3. If you inch window up does same when reaching top . tried reset as per drivers handbook and all methods I've come across on forum but no joy............HELP

if its going up then dropping it the emergency drop, like you would want it to do if a child head or hand was stuck in it

check each side runner were the windows glides up for debris and maybe add a little lube to free the gliding and try again Former Mod/Member, with the most post & Chicken George Arch nemesis

You could try a window reset...

Captain Worm wrote:

It took me a couple of times to do the reset, make sure you follow the procedure exactly as outlined below;

1. Close the window fully.
2. Release the switch, then lift it to the close
position and hold for two seconds.
3. Open the window fully.
4. Release the switch, then push it to the
open position and hold for two seconds.
5. Lift and release the switch to operate the
one touch function.
6. Repeat the procedure on each window.

Thanks for the ideas, tried both still no joy. If you inch window up to closed position then lift button again to close position window drops to 2/3 open

I believe that these things work by sensing the current in the motor, this saves the manufacturer having to put switches at each end of the travel to determine end points. So I wonder if there is some obstruction or tightness near the top of the travel such that the motor has to work harder and the extra current is being sensed as an obstruction or alternatively perhaps the motor is shorting out internally. What happens if you try to "help it close" by getting someone to push the glass upwards whilst you try to close it? 3 x FL1 2 manual + 1 auto
5 x FL2 4 manual + 1 auto
Now Discovery Sport P250 MHEV SE

I had this on mine. Only cured by disconnecting the battery for a while then doing the window reset. Silver 2009 HSE

Thanks for the prompt replies, the window moves smoothly up and down at same speed as other windows, no sign of any obstructions or problems with channel. But still on reaching its "closed" position it drops to a 2/3 open. I have not tried disconnecting battery yet that will be next. But off on holiday (pedaling round Tuscany ) so things will have to wait till I return. Once again thanks for all your help.

According to your instructions,
I fixed it.
Thanks.

HappyNomad wrote:

You could try a window reset...

Captain Worm wrote:

It took me a couple of times to do the reset, make sure you follow the procedure exactly as outlined below;

1. Close the window fully.
2. Release the switch, then lift it to the close
position and hold for two seconds.
3. Open the window fully.
4. Release the switch, then push it to the
open position and hold for two seconds.
5. Lift and release the switch to operate the
one touch function.
6. Repeat the procedure on each window.