Forum-Gallery-Shop-Sponsors

« Advertise on Freel2.com

Home > Maintenance & Modifications > Rear Wheel/Hub Bearing
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
Badger51



Member Since: 01 Mar 2014
Location: Coffs Harbour
Posts: 962

Australia 
Rear Wheel/Hub Bearing

Changed R/H rear yesterday & it was much easier than I expected it to be.

You will need access to a decent workshop press & the necessary tubes, blocks etc for pressing with.

The worst part of the whole exercise was releasing the recessed clip that holds the park brake cable into the hub!

I was lucky enough to also have access to a lathe, so made up a tube that fitted over the cable & compressed the 3 retaining lugs at the same time, the cable then slipped out easily.

For anyone that's interested, the tube has to have an ID of 12mm & an OD of 15.5mm & was 50mm long.

Cheers,

Nick (Now Sold). 2008 Freelander 2 (Nazca Sand) SE TD4 Auto. Statutory write off & on WOVR for hail damage but still road legal.
171037Km as of 09/05/22
Superchips Bluefin Flash
Nanocom Evo II (also sold)

Post #276376 19th Sep 2015 11:37 pm
View user's profile Send private message View poster's gallery Reply with quote
Badger51



Member Since: 01 Mar 2014
Location: Coffs Harbour
Posts: 962

Australia 

L/H rear wheel bearing has now started to hum, much worse with weight in the boot.

Just as well I have one in stock!

Next Saturday will be the day to get it done. (Now Sold). 2008 Freelander 2 (Nazca Sand) SE TD4 Auto. Statutory write off & on WOVR for hail damage but still road legal.
171037Km as of 09/05/22
Superchips Bluefin Flash
Nanocom Evo II (also sold)

Post #336409 2nd Dec 2017 8:59 am
View user's profile Send private message View poster's gallery Reply with quote
rnlisg



Member Since: 10 Oct 2016
Location: romney marsh kent
Posts: 400

England 2013 Freelander 2 SD4 HSE Auto Santorini Black

Well at least you know how to do it Whistle
Thumbs Up gone
P38 v8 auto no problems,great howle from exhausts when giving it welly
Td5 auto head gasket,no5 pot not uncommon but good car.
1st Tdv6s manual epb problem fixed under warranty(stealer said"never heard of this before,i suggested he looked at d3 forum.
2nd Tdv6 se auto epb
3rd Tdv6 xs auto 2008,swmbo,s favourite.

Post #337333 15th Dec 2017 7:57 pm
View user's profile Send private message View poster's gallery Reply with quote
Largered



Member Since: 10 Jul 2016
Location: UK
Posts: 1978

.... you should always change them in PAIRs. Rolling Eyes

.

Post #337334 15th Dec 2017 8:02 pm
View user's profile Send private message View poster's gallery Reply with quote
Badger51



Member Since: 01 Mar 2014
Location: Coffs Harbour
Posts: 962

Australia 

Sorry, will have to agree to disagree about that Razz (Now Sold). 2008 Freelander 2 (Nazca Sand) SE TD4 Auto. Statutory write off & on WOVR for hail damage but still road legal.
171037Km as of 09/05/22
Superchips Bluefin Flash
Nanocom Evo II (also sold)

Post #337341 15th Dec 2017 11:27 pm
View user's profile Send private message View poster's gallery Reply with quote
BadBuy



Member Since: 15 Dec 2017
Location: St. Anthéme
Posts: 28

France 2007 Freelander 2 TD4 HSE Manual Tonga Green

Yes,changing them in pairs is a myth.

Post #337343 16th Dec 2017 3:58 am
View user's profile Send private message View poster's gallery Reply with quote
Mikey



Member Since: 07 Jun 2008
Location: Dundee
Posts: 780

Scotland 2012 Freelander 2 SD4 HSE Auto Baltic Blue

If it was 2 months apart, I'd be inclined to agree.

2 years apart though... Laughing

Post #337345 16th Dec 2017 4:28 am
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
Largered



Member Since: 10 Jul 2016
Location: UK
Posts: 1978

I'm an Olde Engineer who can make anything, 45yrs experience.

People are more willing to 'Repair' their vehicle then conduct 'Preventive Maintenance'

The only myth is ......... people think they are saving money ....... NO ... just doing the job twice !


Question

Post #337361 16th Dec 2017 10:02 am
View user's profile Send private message View poster's gallery Reply with quote
BadBuy



Member Since: 15 Dec 2017
Location: St. Anthéme
Posts: 28

France 2007 Freelander 2 TD4 HSE Manual Tonga Green

I'm sure you know more than most if you been inginearlimgs for a Lifetime.

I had the conversation just recently with my current garage as I've been fixing my Landrovers for some time now Neutral . He looked at it slightly more simply..

Essentially, things that work in pairs are better changed as pairs, things that don't, it don't-make-no-never-mind. On an older car then Discs yep, pads yep, springs yep, shocks yep, anything that 'balances' the car.

However, if you have a newer car which may have been in a prang you are never likely to change both front shocks if only the right side has been damaged.

Post #337388 16th Dec 2017 5:00 pm
View user's profile Send private message View poster's gallery Reply with quote
Largered



Member Since: 10 Jul 2016
Location: UK
Posts: 1978

Have I wasted my life Whistle

you youngsters , you always want to 'take the myth'......!Thumbs Up

Post #337390 16th Dec 2017 5:34 pm
View user's profile Send private message View poster's gallery Reply with quote
IanMetro



Member Since: 11 Sep 2017
Location: Somerset BS21
Posts: 3126

United Kingdom 2014 Freelander 2 SD4 Metropolis LE Auto Fuji White

I'm inclined to agree with most of what Badbuy AND Largered have said when you consider mechanical components.

For electronic components it is different, they can have a poor shelf/handling life and will fail quickly after fitting or last a very long time with little or no deterioration, and each subunit has normally little effect on the subunits around it.

Mechanical components wear slowly through their life and benefit from the occasional bit of love (or maintenance as we engineers call it)

If one item in a pair, chain or set is changed during its lifetime, then you must consider the stress on the rest, or whether as in the suspension the response will be balanced. (for example I would always change all 4 shock absorbers)

As I was involved with costings of long term or even lifetime maintenance, I must admit to tending to go on the cautious side, so we had a bit of profit.

For a business you have to weigh up the differences of cost of maintenance against early replacement. I believe that this led to the invention of sealed 'lifetime' components. FL2 XS SD4 Auto 2010 2012-2017 (21k - 91k miles) (MY2011)
FL2 Metropolis SD4 Auto 2014 2017- (16k - 77k+ miles) (MY2015)
Metro in its 11th Year of (Extended) LR Warranty / Full LR Service History
(Expensive, but Trouble/Worry free - hopefully?)

Post #337393 16th Dec 2017 7:13 pm
View user's profile Send private message View poster's gallery Reply with quote
BadBuy



Member Since: 15 Dec 2017
Location: St. Anthéme
Posts: 28

France 2007 Freelander 2 TD4 HSE Manual Tonga Green

Largered wrote:
Have I wasted my life Whistle

you youngsters , you always want to 'take the myth'......!Thumbs Up


Indeed you may have, but that may require copious amounts of alcohol down an 'ye olde english pub' to determine... Very Happy

All I can be sure of is I wasted a great deal of mine which I am currently making up on.

"Youngsters" Rolling with laughter . I wish.

Post #337394 16th Dec 2017 7:27 pm
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
Freel2.com RSS Feed - All Forums


Switch to Mobile site