| Author |
Message |
 2.2 diesel starts revs to 600 rpm then stops. Help! |
The dog
 4th Nov 2017 8:55 pm
|
Forum: Technical · Replies: 21 · Views: 11479 · Subject: 2.2 diesel starts revs to 600 rpm then stops. Help! |
Fellows, Well its fixed at last  Turns out they replaced the fuel rail which includes the pressure regulator and the pressure sensor, so unfortunately I'll never know which actual component failed. ... |
| 2.2 diesel starts revs to 600 rpm then stops. Help! |
The dog
28th Oct 2017 7:39 pm
|
Forum: Technical · Replies: 21 · Views: 11479 · Subject: 2.2 diesel starts revs to 600 rpm then stops. Help! |
| The car has ended up in the 4x4 Land Rover specialist garage luckily the owner is a good sort and is keen to bottom out the problem without skinning me. So far they have not found the problem. Their ... |
| 2.2 diesel starts revs to 600 rpm then stops. Help! |
The dog
12th Oct 2017 8:09 pm
|
Forum: Technical · Replies: 21 · Views: 11479 · Subject: 2.2 diesel starts revs to 600 rpm then stops. Help! |
Thanks oldgeezer . I like the idea of the return line back pressure possible problem. I guess I could simply disconnect the return line to tank at the fuel filter.
Has there been any known problems ... |
| 2.2 diesel starts revs to 600 rpm then stops. Help! |
The dog
10th Oct 2017 8:37 am
|
Forum: Technical · Replies: 21 · Views: 11479 · Subject: 2.2 diesel starts revs to 600 rpm then stops. Help! |
Hi Yorkie Bob,
No it doesn't go on to idle only reached 600rpm and immediately cuts out. Throttle pedal position makes no difference. Always starts on the button but then cuts at 600rpm.
Autel OBDI ... |
| 2.2 diesel starts revs to 600 rpm then stops. Help! |
The dog
9th Oct 2017 8:48 pm
|
Forum: Technical · Replies: 21 · Views: 11479 · Subject: 2.2 diesel starts revs to 600 rpm then stops. Help! |
| I forgot to mention that I had blanked off the EGR valve at the inlet manifold end however I wouldn't have thought this would have caused the starting problem that's now appeared? All ideas most wel ... |
| 2.2 diesel starts revs to 600 rpm then stops. Help! |
The dog
9th Oct 2017 12:30 pm
|
Forum: Technical · Replies: 21 · Views: 11479 · Subject: 2.2 diesel starts revs to 600 rpm then stops. Help! |
| Fellows the tanks is half full and the fuel rail pressure is good when cranking at around 4400psi No air bubbles in the transparent fuel lines. No water in tank and the fuel is fresh. It ran splendi ... |
| 2.2 diesel starts revs to 600 rpm then stops. Help! |
The dog
8th Oct 2017 8:12 pm
|
Forum: Technical · Replies: 21 · Views: 11479 · Subject: 2.2 diesel starts revs to 600 rpm then stops. Help! |
| Hi Billion yes the exhausts fine, good shout though. Thanks, The dog |
| 2.2 diesel starts revs to 600 rpm then stops. Help! |
The dog
7th Oct 2017 9:03 pm
|
Forum: Technical · Replies: 21 · Views: 11479 · Subject: 2.2 diesel starts revs to 600 rpm then stops. Help! |
| Hi Billio, Yes tried all I know today. The fuel filter was new 40 mile ago. I even tried running it with the throttle flap assembly removed from the manifold but still wired in ( I can see the flap op ... |
| 2.2 diesel starts revs to 600 rpm then stops. Help! |
The dog
7th Oct 2017 12:25 pm
|
Forum: Technical · Replies: 21 · Views: 11479 · Subject: 2.2 diesel starts revs to 600 rpm then stops. Help! |
| Freelander 2 starts runs up to 600 rpm and then shuts down No fault codes appearing. Was running ok then this suddenly occurred, cam and crank sensor have been renewed. Fuel pressure on cranking is go ... |
| Sticking throttle flap possibly? Just fires then stops |
The dog
6th Oct 2017 8:25 pm
|
Forum: Technical · Replies: 3 · Views: 2329 · Subject: Sticking throttle flap possibly? Just fires then stops |
| Well I removed the throttle valve assembly but left it plugged-in electrically, switched on and off the ignition the throttle flap operated as it should. I tried to start the engine with the throttle ... |
| Fault code boost control position sensor 2562-63 |
The dog
5th Oct 2017 9:19 pm
|
Forum: Technical · Replies: 6 · Views: 2900 · Subject: Fault code boost control position sensor 2562-63 |
| Further to my last post on this subject. I disconnected the actuator to turbo variable vane operating arm linkage at the actuator end to check to see how free the vanes moved , they were almost stuck ... |
| Sticking throttle flap possibly? Just fires then stops |
The dog
5th Oct 2017 9:04 pm
|
Forum: Technical · Replies: 3 · Views: 2329 · Subject: Sticking throttle flap possibly? Just fires then stops |
Thanks Andy I'll take a look at the throttle flap tomorrow. No mother-in-law stay over threats on me though  |
| Sticking throttle flap possibly? Just fires then stops |
The dog
2nd Oct 2017 9:25 pm
|
Forum: Technical · Replies: 3 · Views: 2329 · Subject: Sticking throttle flap possibly? Just fires then stops |
Freelander 2.2 diesel was running great but then refused to start and continue running, it does fire for a second or so then dies. Fuel rail pressure is good and no trouble codes are showing.
I'm to ... |
| Fault code boost control position sensor 2562-63 |
The dog
10th Sep 2017 5:20 pm
|
Forum: Technical · Replies: 6 · Views: 2900 · Subject: Fault code boost control position sensor 2562-63 |
| So far due to its location I have not disconnected the actuator from the turbo vane linkage but was wondering if there was a way of testing the actuator function when disconnected from the turbo or po ... |
| Fault code boost control position sensor 2562-63 |
The dog
30th Aug 2017 8:14 pm
|
Forum: Technical · Replies: 6 · Views: 2900 · Subject: Fault code boost control position sensor 2562-63 |
Thanks Yorky Bob.
I had the car on the pit this evening and had a look at the turbo vane linkage and actuator, I didn't disconnect the actuator linkage but couldn't move the actuator at all (using a ... |
| |
