How big a job is it to replace the PTU on a sd4 auto, mine is making a noise. Got the use of a 2 post lift to do the job.
Thanks
Dilwyn

Bell Engineering had mine off and on in half a day.

No special JLR tools needed.

AFAIK all the info is in the free JLR workshop manual downloadable from this site- home>general Jules

Thanks will se if I can find the manual

here

https://www.dropbox.com/s/n0e6q5jj1l1fe2z/...6-2010.pdf Jules

Thanks for the link, very helpful.
Cheers
Dilwyn

www.freel2.com/forum/topic14659-90.html

Depends on how long it takes for you to remove the sleeve coupling between ptu and gearbox. It might also be the case that you do not have to replace the sleeve but i doubt it. Did mine in 8 hours, 4 of thoae were figuring out how to remove the sleeve. Apart from that, not that hard.

Replaced the PTU today simple job in the end drove on lift at 10.15 went for a test drive 13: 15.
bearings noisy on the old unit

Glad its fixed.

Did you do it yourself?
From where did you source a replacement PTU? Jules

Yes, did it myself easy enough job on a lift. Got it from WE are Diffs they do all Land Rover diff and boxes Good price £425 delivered and they pick up old unit.

Great to hear! In what condition was the sleeve?

The sleeve was good, bit of rust on PTU side but no ware on splines put some copper grease on them and put it back

Dilly wrote:

Yes, did it myself easy enough job on a lift. Got it from WE are Diffs they do all Land Rover diff and boxes Good price £425 delivered and they pick up old unit.