So I’ve clearly been a bad person in a former life.

I finally got the right rear discs and pads and all fitted along with a new calliper and hose. Took the cap off the reservoir and it dropped down the side. This seems to be a self contained metal area and I can’t reach it. Is there another way in or just order a new cap? FL2 TD4 GS 60 reg Facelift - so many issues
2019 DS. Terribly unreliable.
Sold DS for a 2021 Mitsubishi Outlander PHEV. Fingers crossed....
Sold Outlander for a 2014 SD4 SE Tech because I’m mental
Now greatly regret selling the Outlander. MPG of the FL2 is atrocious and so are the fuel bills. Fun though 😎
Couldn’t afford the fuel bills so back to an older Mitsubishi Outlander PHEV. Significantly better than I remembered it to be…

get a stick with a dollop of blue tack on it and try to fish it out. 2013 FL2 XS.
Defender 90 300 TDi.
Defender 90 300 TDi CSW.
1964 MGB Roadster.
1944 Willys MB "Jeep" with bullet holes. (gone)
17 hand Irish Drought Thoroughbred (mostly lame)
Nagging Old Boiler.

Mahatma Gandhi said if there is an Idiot in power those who elected him are well represented

Have tried, it’s under some hoses - was hoping it might fall out the bottom like most things but this seems to be a closed space. FL2 TD4 GS 60 reg Facelift - so many issues
2019 DS. Terribly unreliable.
Sold DS for a 2021 Mitsubishi Outlander PHEV. Fingers crossed....
Sold Outlander for a 2014 SD4 SE Tech because I’m mental
Now greatly regret selling the Outlander. MPG of the FL2 is atrocious and so are the fuel bills. Fun though 😎
Couldn’t afford the fuel bills so back to an older Mitsubishi Outlander PHEV. Significantly better than I remembered it to be…

Is it sat on the top of the under tray/sump guard?

No, the reservoir sits in what seems to be a separate compartment to the engine bay. It fell down the side of the reservoir so there’s little space available to even get a look in

The compartment may be open at the bottom, I can’t tell… FL2 TD4 GS 60 reg Facelift - so many issues
2019 DS. Terribly unreliable.
Sold DS for a 2021 Mitsubishi Outlander PHEV. Fingers crossed....
Sold Outlander for a 2014 SD4 SE Tech because I’m mental
Now greatly regret selling the Outlander. MPG of the FL2 is atrocious and so are the fuel bills. Fun though 😎
Couldn’t afford the fuel bills so back to an older Mitsubishi Outlander PHEV. Significantly better than I remembered it to be…

So the only way the is to remove the wiper arms and undo the black plastic cover that covers the wiper mechanism and reservoir. Or just get a new one but knowing JLR prices you might need to remortgage ! 2013 FL2 XS.
Defender 90 300 TDi.
Defender 90 300 TDi CSW.
1964 MGB Roadster.
1944 Willys MB "Jeep" with bullet holes. (gone)
17 hand Irish Drought Thoroughbred (mostly lame)
Nagging Old Boiler.

Mahatma Gandhi said if there is an Idiot in power those who elected him are well represented

If you pop out all the plastic clips along the front edge you may just get in just enough.

There are some photos under the plastic panel here:
https://www.freel2.com/forum/topic33026-54.html Procrastination, mankind's greatest labour saving device!

Acoustic insulation ARB TPMS 3xARB air compressors After cooler Air tank On-board OCD pressure air/water cleaning Additional 50L fuel Carpet in doors ABE 2x1kg Waeco 28L modified fridge Battery 4x26ah Solar 120w Victron MPPT 100/20 DC-DC 18amps 175amp jumper plug Awning 6x255/60R18

Thanks both. I’ll have another look this morning. I’ve ordered a few off Amazon for delivery today in case one of them fits. Supposed to fit most Ford models. FL2 TD4 GS 60 reg Facelift - so many issues
2019 DS. Terribly unreliable.
Sold DS for a 2021 Mitsubishi Outlander PHEV. Fingers crossed....
Sold Outlander for a 2014 SD4 SE Tech because I’m mental
Now greatly regret selling the Outlander. MPG of the FL2 is atrocious and so are the fuel bills. Fun though 😎
Couldn’t afford the fuel bills so back to an older Mitsubishi Outlander PHEV. Significantly better than I remembered it to be…

Got it. Many hours with a USB inspection camera locating it then getting something small and flexible enough to reach the cap. Ended up putting hot glue on the end and quickly locating the cap. Worked like a charm


 FL2 TD4 GS 60 reg Facelift - so many issues
2019 DS. Terribly unreliable.
Sold DS for a 2021 Mitsubishi Outlander PHEV. Fingers crossed....
Sold Outlander for a 2014 SD4 SE Tech because I’m mental
Now greatly regret selling the Outlander. MPG of the FL2 is atrocious and so are the fuel bills. Fun though 😎
Couldn’t afford the fuel bills so back to an older Mitsubishi Outlander PHEV. Significantly better than I remembered it to be…

And dont drop it again  Jules

Drill a hole in one corner (as one says: the corner of the World) & attach a "string line"... to the edge of the cap.

But then again, remove the wipers & give the area between the two fire walls a good clean. While at it install acoustic insulation!

You could even add a pre low level dust/dirt filter over the intake into the cabin while at it. A piece of open cell foam https://www.bunnings.com.au/jack-900mm-gut...p_p3042417 Procrastination, mankind's greatest labour saving device!

Acoustic insulation ARB TPMS 3xARB air compressors After cooler Air tank On-board OCD pressure air/water cleaning Additional 50L fuel Carpet in doors ABE 2x1kg Waeco 28L modified fridge Battery 4x26ah Solar 120w Victron MPPT 100/20 DC-DC 18amps 175amp jumper plug Awning 6x255/60R18

Definitely a good idea about putting a tie on it.

As for removing the wipers etc, I think my nerves have had enough of trying to undo 10 year old joints that may or may not create more work for me 😂

Maybe in a few months… FL2 TD4 GS 60 reg Facelift - so many issues
2019 DS. Terribly unreliable.
Sold DS for a 2021 Mitsubishi Outlander PHEV. Fingers crossed....
Sold Outlander for a 2014 SD4 SE Tech because I’m mental
Now greatly regret selling the Outlander. MPG of the FL2 is atrocious and so are the fuel bills. Fun though 😎
Couldn’t afford the fuel bills so back to an older Mitsubishi Outlander PHEV. Significantly better than I remembered it to be…

Probably best change the fluid now its been exposed for a few days.  
Hung like Einstein, smart as a horse.

Chuckalicious wrote:

Definitely a good idea about putting a tie on it.

As for removing the wipers etc, I think my nerves have had enough of trying to undo 10 year old joints that may or may not create more work for me 😂

Maybe in a few months…

The issue with wipers is that they can be really hard to pull off the splines if corroded. I bought a mini-puller for them.


 Jules