I have had a roll of carbon fibre wrap kicking about for a few years that was going to be used on another project that never happened. My bonnet has a patch of crazing about the size of a 50p, so rather than going to the expense of sorting it and because I had the wrap, I decided to use it to cover it up.
I was restricted by the width of the roll,it could've stood to have been slightly wider. I'm also in two minds as to whether to put it on the bumper , under the grille, or even the roof above the windsscreen - as that has a couple of stone chips that have been touched up.
But, I might just get rid of it altogether.











Last edited by RealBeale on 21st Feb 2023 11:53 pm. Edited 1 time in total

Good luck with that.

Ive got an aching neck now  Jules

Yeah , Jules. It was a real pain getting the wrap on that bonnet with the Freelander at such an angle

 Jules

Just go in to your Gallery, select image, 'Crop and Rotate', then select 'Rotate', select '-90 180 +90', 'Save picture', easy.

Otherwise it will be impossible to do the driver's door and the film will fall off. Maybe flowers film would look better! Procrastination, mankind's greatest labour saving device!

Acoustic insulation ARB TPMS 3xARB air compressors After cooler Air tank On-board OCD pressure air/water cleaning Additional 50L fuel Carpet in doors ABE 2x1kg Waeco 28L modified fridge Battery 4x26ah Solar 120w Victron MPPT 100/20 DC-DC 18amps 175amp jumper plug Awning 6x255/60R18

I quite fancy doing the grill, bonnet centre and roof above the front screen in gloss black. Hyundai Ioniq 5 Ultimate. The family car.
2009 Rimini Red SE TD4. Gone.
2006 Tonga Green i6 HSE. Gone.
Audi A5 convertible, my daily driver.
1972 Hillman Avenger GT, the project.

Reminded me of this, which I spotted a little while ago .....