I noticed recently that the front offside mud flap has been somehow come away slightly from the body. It’s not obviously loose and nor will it push back into position.


I’ve looked at the Powerful UK video on how to fit them and there’s clearly more to doing so than meets the eye. But I can’t work out how it has come apart, nor how to get it back in place.

Can anyone offer any suggestions?

It's come out of the poppers, so it looks like it just needs popping back in. Hyundai Ioniq 5 Ultimate. The family car.
2009 Rimini Red SE TD4. Gone.
2006 Tonga Green i6 HSE. Gone.
Audi A5 convertible, my daily driver.
1972 Hillman Avenger GT, the project.

This happend to me on some rough ground the plastic finisher panel that the flap is fixed to has come off the popper clips line them up properley and give it a good thump with your hand and it will clip back on  2013 FL2 XS.
Defender 90 300 TDi.
Defender 90 300 TDi CSW.
1964 MGB Roadster.
1944 Willys MB "Jeep" with bullet holes. (gone)
17 hand Irish Drought Thoroughbred (mostly lame)
Nagging Old Boiler.

Mahatma Gandhi said if there is an Idiot in power those who elected him are well represented. The Enemy is our own corrupt Government.

Thank you both. Funnily enough when I had another look at the picture a short while ago I noticed the poppers and wondered if a good thump might do the trick. I shall try that tomorrow.

There are two parts there , the front mud flap , which if it is genuine has a quite fussy mounting bracket behind the wheel arch liner , and the plastic trim to the bottom of the wing which has become detached . If you can’t thump it back in place it might need splitting into two before re-assembly . 2009 GS Auto Zermatt Silver - Sold June 21 after 10 years of ownership

2016 Subaru Outback SE 2.0 diesel SE Premium Lineartronic Sold 2024 after 8 years and 80k miles . Best Car I ever owned !

2023 Toyota Hilux invincible X 2.8 Auto .

Fingers crossed a good thump or two will do the trick.

I had to fit a pair to my first FL2, as you said the video shows that you have to mark its position and then remove a few screws and insert bits behind panels.
I would reverse the process (take it apart), inspect bracket and fixings, repair if necessary, and refit.

It's not a big job, and would avoid further damage.

 FL2 XS SD4 Auto 2010 2012-2017 (21k - 91k miles) (MY2011)
FL2 Metropolis SD4 Auto 2014 2017- (16k - 79k+ miles) (MY2015)
Metro in its 11th Year of (Extended) LR Warranty / Full LR Service History
(Expensive, but Trouble/Worry free - hopefully?)

My attempts to simply thump it back in place were unsuccessful so I think I’ll have to try taking the mud flap itself off and see if the plastic cover panel is damaged in some way. Thanks for pointing me to the PowerfulUK video - their stuff is always first class.