3landertwo wrote:

Click image to enlarge

is this what you are looking to do ???

Hi. What wire did you take as the switch for the relay and did you take it from the headlight connector or somewhere else. Thanks in advance

I have mounted mine directly to the grill using stainless washers to pack out the back and keep them facing forward.













Lights are LAP Strolux SLX2-08

https://www.beaconsandlightbars.co.uk/lap-...x2-08.html Current driveway contents:
2021 V60 Cross Country B5
2009 FL2 dog bus and shooting wagon

On Order: 2023 Fisker Ocean Ultra - deposit paid.

Where did you take the switch wire from

Hi Gum,

I took the feed from the main beam feed behind the NS headlamp. I came back about 6" from the connector on the back of the headlamp and carefully took a small section of the tape off the loom. Had a dig around and found the Yellow/Orange wire that feeds main beam and tapped into that. I've then run that through to a separate switch in the cabin, which is only "live" when main beam is on so I have the option of just headlamp main beam or headlamp main and the driving lights.


LHD:
https://www.freel2.com/gallery/albums/user...203061.pdf

RHD:
https://www.freel2.com/gallery/albums/user...%20RHD.pdf


PDF of the wiring diagram for headlamps attached, so you can see what colours do what in that loom. I've put the LHD and RHD versions, although from a quick glance they seem to be the same loom/colour for headlamps Current driveway contents:
2021 V60 Cross Country B5
2009 FL2 dog bus and shooting wagon

On Order: 2023 Fisker Ocean Ultra - deposit paid.

That's brilliant, thanks for your help

Worth noting that this only applies until the new headlights with LED DRLS etc in.... 2014 (?) onwards. These final facelift lights have a different loom. Current driveway contents:
2021 V60 Cross Country B5
2009 FL2 dog bus and shooting wagon

On Order: 2023 Fisker Ocean Ultra - deposit paid.

Hmm. Mines a 13 with round led DRLs, so I guess my loom is different. Has anyone a facelift wiring diagram

You may want to have a read of this thread:

https://www.freel2.com/forum/topic37889-15.html Current driveway contents:
2021 V60 Cross Country B5
2009 FL2 dog bus and shooting wagon

On Order: 2023 Fisker Ocean Ultra - deposit paid.

Why are modern cars so difficult

Gum77 wrote:

Hmm. Mines a 13 with round led DRLs, so I guess my loom is different. Has anyone a facelift wiring diagram

I measured up my 24" LED light bar too see if it would fit between the deflection shields behind the grill, and there is enough room for it. I also want the better light output of my LED bar over the main beam bulbs.
The only hard part would be working out how to support the LED bar in the centre of the grill space, but I think a stout tube running across between the deflection shields will work to support the LED bar. It could also be made adjustable for up and down aiming. It's on my ToDo list. Hyundai Ioniq 5 Ultimate. The family car.
2009 Rimini Red SE TD4. Gone.
2006 Tonga Green i6 HSE. Gone.
Audi A5 convertible, my daily driver.
1972 Hillman Avenger GT, the project.

Yes it's going to be a bumper off job which is putting me off! FL2 SD4 XS 2013 Orkney Grey

It only takes 30 minutes to remove the front bumper, less if there's no front wasters. Hyundai Ioniq 5 Ultimate. The family car.
2009 Rimini Red SE TD4. Gone.
2006 Tonga Green i6 HSE. Gone.
Audi A5 convertible, my daily driver.
1972 Hillman Avenger GT, the project.

Yes and I must admit FL2s don't seem to suffer too much from rusting bolts etc.

I have no garage so it's a.job for next summer and looks like a two man job of you are to avoid damaging the paintwork. FL2 SD4 XS 2013 Orkney Grey