Forum-Gallery-Shop-Sponsors

« Advertise on Freel2.com

Home > Technical > Beeps once when turned on, doesn’t start
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
QUERCUS



Member Since: 21 Jun 2006
Location: Suomi
Posts: 157

2007 Freelander 2 i6 HSE Auto Stornoway Grey
Beeps once when turned on, doesn’t start

2007 i6 doesn’t start. Beeps once when ignition is turned on. 2007 Freelander 2 HSE i6
stornoway grey
black leather

Post #411325 13th Aug 2021 1:27 pm
View user's profile Send private message View poster's gallery Reply with quote
merlinj79



Member Since: 13 Aug 2019
Location: San Diego
Posts: 315

United States 2008 LR2 i6 S Auto Tambora Flame

Battery good? Obviously needs a good charge, but this car also doesn't do well with an older, tired battery. In Finland you probably need to replace it every four years.

Try a computer reset...

Disconnect battery cables
Wait 10 minutes
Touch cables together, then reconnect
Wait 10 minutes
Insert key fob
Wait 10 minutes
Turn vehicle, but don't start (foot off brake, hold ignition button)
Wait 10 minutes
Try starting

Post #411328 13th Aug 2021 3:15 pm
View user's profile Send private message View poster's gallery Reply with quote
QUERCUS



Member Since: 21 Jun 2006
Location: Suomi
Posts: 157

2007 Freelander 2 i6 HSE Auto Stornoway Grey

Will try resetting as advised, thanks. Didn’t jumpstart with cables so shouldn’t be the battery. 2007 Freelander 2 HSE i6
stornoway grey
black leather

Post #411344 14th Aug 2021 7:41 am
View user's profile Send private message View poster's gallery Reply with quote
Jagracer



Member Since: 22 Feb 2019
Location: east anglia
Posts: 198

United Kingdom 2009 Freelander 2 TD4 GS Manual Bali Blue

HI, the I6 is a Volvo engine with Ford logos on it. It was also fitted in a Volvo S80, Volvo V70. If the battery is showing over nine volts at start, then the Key Module is a known failure part. My 2008 FL2 had this problem, which turned out to be the Crash Sensor had actioned and shut down the electrics. A tricky one to trace and fix. Turned out to be a faulty wire on the left hand inner wing near the fuse box.

Post #411348 14th Aug 2021 9:18 am
View user's profile Send private message View poster's gallery Reply with quote
QUERCUS



Member Since: 21 Jun 2006
Location: Suomi
Posts: 157

2007 Freelander 2 i6 HSE Auto Stornoway Grey

Does the “beep” after switching ignition on indicate anything? Instead of starting, it sounds a beep. 2007 Freelander 2 HSE i6
stornoway grey
black leather

Post #411354 14th Aug 2021 12:03 pm
View user's profile Send private message View poster's gallery Reply with quote
RealBeale



Member Since: 13 Jun 2016
Location: Birmingham Great Barr
Posts: 915

United Kingdom 2007 Freelander 2 i6 HSE Auto Sumatra Black

Starter motor. If the signal isn't found by the ecu, then you get a beep and nothing else. I had this happen to me on my i6. Bought a new battery but it still did the same.Fitted an extra earth lead, still the same. Changed the starter motor - fired up immediately. Brushes in the starter motor were virtually all worn away.
It's something along the lines of not getting a pulse from the starter, so it will not go through the rest of the starting procedure.

Post #411373 15th Aug 2021 10:45 pm
View user's profile Send private message View poster's gallery Reply with quote
merlinj79



Member Since: 13 Aug 2019
Location: San Diego
Posts: 315

United States 2008 LR2 i6 S Auto Tambora Flame

Good to know. The starters will wear out on these cars.

Post #411398 16th Aug 2021 2:11 pm
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
Freel2.com RSS Feed - All Forums


Switch to Mobile site