Forum-Gallery-Shop-Sponsors

« Advertise on Freel2.com

Home > Technical > Door pocket removal
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
Philip16storm



Member Since: 03 Jun 2020
Location: North yorkshire
Posts: 28

United Kingdom 
Door pocket removal

Hi all, I noticed the lamp in the bottom of my passenger side door was out so went to replace the bulb, unfortunately someone has already tried this and lost the end of the wire in the door! I certainly don't want to have to remove the whole door card and wondered if just the lower part which makes up the outer of the door pocket could be removed on its own, I tried removing the one screw but still seems like there is a lot of resistance and don't want to force it if I may damage it.
Thanks in advance for any help.

Post #404947 7th Mar 2021 1:26 pm
View user's profile Send private message View poster's gallery Reply with quote
MotionInc



Member Since: 17 Jun 2019
Location: North America
Posts: 1355

Canada 2008 LR2 i6 SE Auto Tambora Flame

I've not have to do this myself but google search results:
https://www.google.com/search?q=FL2%20door%20card%20removal

In that search, there is also a link to this forum. Thumbs Up

Post #404948 7th Mar 2021 2:13 pm
View user's profile Send private message View poster's gallery Reply with quote
Nodge68



Member Since: 15 Jul 2020
Location: Newquay
Posts: 2082

United Kingdom 2009 Freelander 2 TD4 SE Manual Rimini Red
Re: Door pocket removal

Philip16storm wrote:
Hi all, I noticed the lamp in the bottom of my passenger side door was out so went to replace the bulb, unfortunately someone has already tried this and lost the end of the wire in the door! I certainly don't want to have to remove the whole door card and wondered if just the lower part which makes up the outer of the door pocket could be removed on its own, I tried removing the one screw but still seems like there is a lot of resistance and don't want to force it if I may damage it.
Thanks in advance for any help.


The pocket will be an integral part of the door card. It's not difficult or long winded to remove the card. Hyundai Ioniq 5 Ultimate. The family car.
2009 Rimini Red SE TD4. Gone.
2006 Tonga Green i6 HSE. Gone.
Audi A5 convertible, my daily driver.
1972 Hillman Avenger GT, the project.

Post #404950 7th Mar 2021 2:25 pm
View user's profile Send private message View poster's gallery Reply with quote
Lightwater



Member Since: 21 Aug 2014
Location: Sydney Northern Beaches
Posts: 4906

Ukraine 2013 Freelander 2 2.0T SE Auto Fuji White

Do NOT pull on the door pocket under any circumstances. You will snap off lugs from the inside of the trim panel & then you will have to work out how to reattach the pocket.

It's not difficult to remove the trim panel. There are 2 screws behind the handle trim, which you lever up from the bottom edge to remove, it's tough the first time. 1 screw at the door release lever. 1 screw lower down on the door. 1 screw at the back edge of the door near the top, remove this even if pulling out the panel a bit. So 5 screws in total. Remember where they go as there are 2 lengths.

Then get under the bottom edge of the panel, rear corner & give the panel an extremely short sharp tug to free the trim clips.

If 1 or 2 break, respace them, more than that get some extras.

Part numbers & door internal photos in this thread: https://www.freel2.com/forum/topic33026.html Procrastination, mankind's greatest labour saving device!

Acoustic insulation ARB TPMS 3xARB air compressors After cooler Air tank On-board OCD pressure air/water cleaning Additional 50L fuel Carpet in doors ABE 2x1kg Waeco 28L modified fridge Battery 4x26ah Solar 120w Victron MPPT 100/20 DC-DC 18amps 175amp jumper plug Awning 6x255/60R18

Post #404976 7th Mar 2021 8:36 pm
View user's profile Send private message View poster's gallery Reply with quote
Philip16storm



Member Since: 03 Jun 2020
Location: North yorkshire
Posts: 28

United Kingdom 

Thanks for the very useful info, I will give it a go! 😬😬

Post #405119 11th Mar 2021 8:58 pm
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
Freel2.com RSS Feed - All Forums


Switch to Mobile site