Home · FAQ · New Posts · My Posts · PMs · Search · Members · Members Map · Calendar · Profile · Donate · Register · Log In |
Home > Technical > P245 Fault on 2011 HSE TD4 |
|
|
MotionInc Member Since: 17 Jun 2019 Location: North America Posts: 1355 |
I have never owner a diesel but I searched the code you posted on the forum and here are the results:
|
||
31st May 2020 2:17 pm |
|
OMGHowMuch18 Member Since: 25 Jul 2018 Location: Loughborough Posts: 14 |
Yes only code and up to now no impact on performance. Just now added battery issue if its related. |
||
31st May 2020 2:23 pm |
|
MotionInc Member Since: 17 Jun 2019 Location: North America Posts: 1355 |
Yeah, a battery that low will likely need replacing or at the very least, reconditioning. Sadly, it will only complicate matters with these vehicles. |
||
31st May 2020 2:33 pm |
|
TooBlue Member Since: 30 Oct 2019 Location: Midlands Posts: 265 |
Have a read here https://www.obd-codes.com/p245a
|
||
31st May 2020 2:59 pm |
|
OMGHowMuch18 Member Since: 25 Jul 2018 Location: Loughborough Posts: 14 |
Currently disconnected battery and charging overnight. See if it starts in the morning. Would a specialist be best to diagnose cause of p245a fault? |
||
31st May 2020 3:05 pm |
|
OMGHowMuch18 Member Since: 25 Jul 2018 Location: Loughborough Posts: 14 |
Could a faulty glow plug module cause all these issues inc battery discharged or has a faulty battery caused it all. But what symtoms would there have been if the battery was deteriorating? |
||
31st May 2020 4:17 pm |
|
Wonderdust Member Since: 23 Mar 2020 Location: Bucks Posts: 161 |
Might be wrong but I honestly don't think you will get that battery back from such a low voltage. It might start in the morning but as for holding a charge that's another matter. Good luck. |
||
31st May 2020 4:31 pm |
|
OMGHowMuch18 Member Since: 25 Jul 2018 Location: Loughborough Posts: 14 |
Just charged it for about 4 hours and multimeter says output is 14.8v, putting it on maintenance charge overnight. I bet its that glow plug module knackering everything up. |
||
31st May 2020 4:50 pm |
|
BossBob Member Since: 30 Sep 2010 Location: Bristol Posts: 1385 |
A high pitched whine after shutting down the engine is normally diagnosed as a problem with the throttle valve.
|
||
31st May 2020 6:11 pm |
|
OMGHowMuch18 Member Since: 25 Jul 2018 Location: Loughborough Posts: 14 |
After my battery has charged i will get the key out of the docking station and i will try locking it to see if that stops the electrical whining. Is the glow plug control module easy to replace? I know it located on the bulkhead near where the wiper motor is but not sure what has to be removed to get to it. Anyone know if having a faulty glow plug module will have knacker a glow plug or two again? |
||
31st May 2020 7:08 pm |
|
OMGHowMuch18 Member Since: 25 Jul 2018 Location: Loughborough Posts: 14 |
Screenshot of code reader screen attached.[/img] |
||
31st May 2020 7:21 pm |
|
OMGHowMuch18 Member Since: 25 Jul 2018 Location: Loughborough Posts: 14 |
Update: Battery charged up and started car just about. Dropped off at garage and waiting for further diagnosis. They still think faulty module causing all the issues. |
||
2nd Jun 2020 1:23 pm |
|
oldgeezer Member Since: 09 Apr 2011 Location: Wiltshire Posts: 1302 |
the code could relate to a turbo charger waste-gate control, but this fault often flags if the battery voltage drops.
|
||
2nd Jun 2020 1:48 pm |
|
OMGHowMuch18 Member Since: 25 Jul 2018 Location: Loughborough Posts: 14 |
Further update.. Picked up car after battery replacement and all seemed fine. But went out shopping ltoday and after a mile or so on dual carriageway eml came on and when plugged into odb reader it said p245a again. So it's had 4 new glow plugs and a new battery. What next? Any ideas? Think I will take it to a local land rover specialist. Any recommendations near Leicester? |
||
4th Jun 2020 5:41 pm |
|
|
All times are GMT |
< Previous Topic | Next Topic > |
Posting Rules
|
Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis