I'm planning on installing some side steps to my car, watching some videos on line, it seems quite simple..

But I know for a fact I'm going to break those panel rivets getting the side trim off.

Does anyone know what size I need to buy in advance?

I recently had to buy a set of fastenings for the lower trim panel after a jacking incident (all pilot error) and have many of them left over.
So if you tell me exactly what you wish me to measure I will be happy to oblige.
The part numbers I bought are LR106831, RYQ500070
These were all ridiculously expensive from Land Rover coming in at well over £30 for a few bits of plastic.
So let me know
David Wright

I emailed the company I bought the sidesteps from and they told me to get these:

https://www.halfords.com/workshop-tools/ga...ets-hfx363

Those kind of look like the RYQ500070 ones.

I've not taken mine off yet, I might go grab a box of the ones from Halfords before I start.

Thanks for the offer, I'll let you know once I get the things off.

Google is your friend

Found this in less than a minute

https://www.vehicleclips.co.uk/vehicle/?ve..._mode=list Jules

Google is not my friend as I could not find that that

Thanks, thats really helpful!

I was looking for weeks for a clip & the above page never showed. Procrastination, mankind's greatest labour saving device!

Acoustic insulation ARB TPMS 3xARB air compressors After cooler Air tank On-board OCD pressure air/water cleaning Additional 50L fuel Carpet in doors ABE 2x1kg Waeco 28L modified fridge Battery 4x26ah Solar 120w Victron MPPT 100/20 DC-DC 18amps 175amp jumper plug Awning 6x255/60R18