Facelift model 2013, originally had manual dim interior mirror, i am replacing it with a FL2 interior mirror with auto dim, i got the old one off okay, then found i have this module stuck to the windscreen with wiring connected to it.
Is it likely the connector for the auto dim mirror is in the headlining?
how do i get the centre light assembly out to look behind it?
View from inside the car with mirror removed


the connector on the new chromatic mirror


view of the sensor assembly attached to the windscreen from outside

Okay, i have found a switched 12v and ground i can pinch from the courtesy light, can anyone confirm which wire colour goes to which terminal in the plug on the mirror, i looked at the wiring diagram on here (for an 09 MY) and whilst it gives the colours of wires going to the plug, i don't have the plug and associated cable so can't determine which pin is which in the mirror socket.

Anyone????

Im pretty sure i recall someone posted about this upgrade recently - do a search If you havent already.
Maybe that OP can help if they see your posting.
Im afraid I can offer no other help.
Good luck. Jules

markflickr wrote:

Anyone????

In http://www.freel2.com/forum/topic11523.html, second page in the middle alex_pescaru writes:

Pin 1, white - switched 12V power
Pin 2, blue - reverse signal
Pin 3, black - ground (GND)
Pin 6, yellow - humidity sense.

But on your photo there is no blue wire but a gray one?

If I had to guess I would connect the switched 12v to the white wire and the ground to the black.

Fantastic. Thank you so much, i scanned those and managed to miss that bit in the middle of all the chatter...