Philippe
Member Since: 12 Feb 2018
Location: Bern
Posts: 1
|
CORREZE wrote:R2RGE
When I opened the box and sat them on the roof there was a bit of a gap between the roof and the centre fixing point but as you bolt them down they fit perfectly. Fixing is easy, on the black roof trim, approx. 200mm from the top of the windscreen, there is a little cross which you drill an 8mm hole through, under this is a large nut which has a plastic coating over it. If you push a small screwdriver through the 8mm hole into the top of the nut it reveals an internal thread in the top of the nut. The rear two fixings, simply remove the black plastic fixing that holds the "gutter" trim on. They are supplied with all fixings, rubber gaskets and some sealant for the threads, you just need an allen key, finish is very good and for me, I prefer the look.
It's a while, but ... I just bought these as well, however, my Freelander is fitted with normal M10 screws in the front fixing points, so no internal thread. I am not sure if the previous owner just fitted them or if this is original. Anyone else with this problem? How does this nut with the internal thread look like?
Regards
Philippe
|
12th Feb 2018 7:47 pm |
|