Hi I have been looking how to remove the service indicator on the dash and have found plenty of threads telling you how to remove it for a FL2 pre-2013 facelift.

I have a 2013 model which has a single screen in the centre of the dash, I have had it serviced but when i start it, I get the message "Service Required". Is this something that can be set by myself or does it have to be done via a garage?

Thank you

This may help
http://www.freel2.com/forum/topic15000.html No Longer the owner of a 2013MY Fuji White GS

"Fiat Lux" a philosophy not a car

I'm sure there was a thread on here within the last week talking about the 2013 service reset, there was a youtube video posted of the Evoque method and it didn't work. And then someone else posted a procedure, something about holding both the brake and the accelerator to the floor...

Can't for the life of me find it now... 2008 Freelander 2 HSE Si6 Black/Black - Hers
2009 Jaguar XKR 4.2 S/C Portfolio
2005 Jaguar XJR 4.2 S/C Black/Cranberry
2005 Jaguar X-Type 3.0L AWD - Gone

I'm sure I answered this yesterday?
(Pre 2014 resets can only be done by diagnostic equipment)

The reset procedure as on the Topix web site.

Manual Service Re-set Procedure for 14my vehicles is now available in TOPIX under section 413-09 Warning Devices - Service Indicator Reset General Procedures,
Also can be found on SDD the application to reset the SIA currently resides in 'Service Functions'.
Manual Service Re-set Procedure for 14my Start VIN’s are as follows and covers Petrol and Diesel engine vehicles

Range Rover Sport L494 14MY from VIN LW300000
Range Rover L405 14MY from VIN LG124982
Discovery 4 L319 14MY from VIN LA699716
Defender L316 14MY from VIN LD446699
Evoque L538 14MY from VIN LV856580
Freelander 2 L359 14MY from VIN LF382339

Warning Devices - Service Indicator Reset

General Procedures
Synchronization

NOTE: Make sure the Land Rover approved diagnostic equipment is not connected to the vehicle.

- Set the ignition to the ON position.
- Open the hood.
- Open the drivers door. NOTE: A service resetting message will appear on the instrument cluster.
- Fully depress both the accelerator and brake pedals and hold for 10 seconds.
- Set the ignition to the OFF position.
- Set the ignition to the ON position and check the message has been cleared.

- If the message remains, repeat the process.

I know i'm not crazy, you did post it, but the thread seems to have vanished. 2008 Freelander 2 HSE Si6 Black/Black - Hers
2009 Jaguar XKR 4.2 S/C Portfolio
2005 Jaguar XJR 4.2 S/C Black/Cranberry
2005 Jaguar X-Type 3.0L AWD - Gone

Thank you Turboextreme.

I guess then, as mine is a 62 plate (December 2012), 2013 facelift model the reset will not work. I will give it a go anyway, just in case.

Cambo wrote:

I know i'm not crazy, you did post it, but the thread seems to have vanished.