Forum-Gallery-Shop-Sponsors

« Advertise on Freel2.com

Home > Maintenance & Modifications > Noise from rear when setting off and turning at same time
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
2spring



Member Since: 16 May 2014
Location: England
Posts: 8

United Kingdom 2007 Freelander 2 TD4 HSE Auto Santorini Black
Noise from rear when setting off and turning at same time

2.2TD4 HSE Auto

Hi all,

When the vehicle hasn't been run for a few hours I get the following problem for up to 15 minutes until it warms up:

If I set off from stationary and turn hard left or right I get a loud, deep, rumbling, grating noise from the rear of the car. Typically this is when approaching a 'T' junction, stopping and then setting off while turning

It stops as soon as the turn is finished and the vehicle is driving in a straight line. The more power/acceleration that is used during the standing start turn, the louder the noise.

It happens on both right and left turns.



Any advice would be really appreciated.

Post #227084 13th Jun 2014 9:08 pm
View user's profile Send private message View poster's gallery Reply with quote
pab



Member Since: 28 Aug 2012
Location: Now in Mid-Wales
Posts: 2006

United Kingdom 2009 Freelander 2 TD4 XS Manual Lago Grey

I'm afraid that sounds very much like a problem with the Haldex. The grating sounds like transmission wind-up due to the Haldex not releasing when it should.

Post #227089 13th Jun 2014 9:45 pm
View user's profile Send private message View poster's gallery Reply with quote
2spring



Member Since: 16 May 2014
Location: England
Posts: 8

United Kingdom 2007 Freelander 2 TD4 HSE Auto Santorini Black

Thanks for your help. Have you any idea why it only happens within 15 minutes of starting?

Also, I am probably clutching at straws here, but is there a chance it could just be the exhaust rattling against something- given that it seems to go away after everything warms up ?

Post #227091 13th Jun 2014 9:48 pm
View user's profile Send private message View poster's gallery Reply with quote
pab



Member Since: 28 Aug 2012
Location: Now in Mid-Wales
Posts: 2006

United Kingdom 2009 Freelander 2 TD4 XS Manual Lago Grey

These things can be temperature sensitive. I used to have a Subaru whose centre coupling would lock up, but only when it was hot.

Without hearing the noise it's difficult to say what's causing it. It could be something like the exhaust, but the turning aspect could be a symptom of a Haldex problem. If the noise is transmission wind-up it may be accompanied by a slight shuddering or vibration as the tyres slip - are you getting anything like that?

Post #227098 14th Jun 2014 8:00 am
View user's profile Send private message View poster's gallery Reply with quote
alex_pescaru



Member Since: 12 Mar 2009
Location: RO
Posts: 4642

If it's Haldex related, it may be the beginning of the end of your Haldex, but I would change the Haldex oil and update the software to the latest firmware.
The latest firmware is a little more fault tolerant and slightly less eager to lock. This also for protecting the known problematic differential attack pinion bearing.

Post #227117 14th Jun 2014 1:04 pm
View user's profile Send private message View poster's gallery Reply with quote
2spring



Member Since: 16 May 2014
Location: England
Posts: 8

United Kingdom 2007 Freelander 2 TD4 HSE Auto Santorini Black

Thanks Pab and Alex.

I tried to record the noise with my phone but learned that doing an accelerating turn from a standing start while messing with my phone required advance planning and the the recordings are useless. Lol !

This possible fault is going to be checked by a LR dealer and I will post the result/progress here in due course.

We bought the car last year following the infamous '12-'13 winter. It has a low mileage (<50k) but if the previous owner was playing in the snow with it during that protracted winter and over-revving it then would that explain a Haldex failure?
I ran a milk round in the '78-'79 winter and all I had to do to get around in my old VW pick-up was under-power it to the extent of nearly stalling it, setting off in second etc. - but all the time I watched people endlessly sat around spinning holes under their wheels - including LR drivers !! Maybe knowledge of the excellent off-road capabilities of the FL2 need to be tempered with additional knowledge of both the way to use the Haldex in snow and mud and the way to miss-use it - I shall read the manual.

Anyway, we have got attached to this car because the '07 model's suspension doesn't jerk you around, the shockers actually work and smooth out the road surface irritations, the cabin and seats are total perfection and you arrive at your destination with no particular desire to get out. When we bought it we asked the dealer to remove the 18" wheels and fit 17" with 235/65's which massively reduces long distance fatigue. I know that changing 18" wheels for 17" is going against what most people do, but it works for us and we intend to stick with this car. If it needs a new Haldex then it will get one.

Post #227118 14th Jun 2014 1:49 pm
View user's profile Send private message View poster's gallery Reply with quote
ad210358



Member Since: 12 Oct 2008
Location: Here and There
Posts: 7464

England 

Surprised by the wheel comment, on my first Freelander I had 18" for summer, 17" for winter, on, you could hardly tell the difference with the bumps, but a bit of roll on the bends with the 17". The second one I had 19" for Summer, 17" again for winter, you could notice the body roll on the bends with 17", the 19" were much more planted on bends, only marginally harder than the 17" on uneven road surfaces.

Post #227119 14th Jun 2014 2:23 pm
View user's profile Send private message View poster's gallery Reply with quote
pab



Member Since: 28 Aug 2012
Location: Now in Mid-Wales
Posts: 2006

United Kingdom 2009 Freelander 2 TD4 XS Manual Lago Grey

2spring wrote:
... if the previous owner was playing in the snow with it during that protracted winter and over-revving it then would that explain a Haldex failure?

I doubt it. More likely just one of those things.
Quote:
... all the time I watched people endlessly sat around spinning holes under their wheels - including LR drivers !!

Yup. The electronics can help, but you still need to have some clue, and many drivers don't seem to!

Post #227123 14th Jun 2014 3:42 pm
View user's profile Send private message View poster's gallery Reply with quote
alex_pescaru



Member Since: 12 Mar 2009
Location: RO
Posts: 4642

The same, 18 for summer and 17 for winter... BIG difference in comfort!
Much smoother on 17, but in the same time, much stable on 18.

Returning to problem at hand... Many people on Russian forum have had the same problem as you.
The problem was much reduced up to non existent when they've changed the oil.
But a thorough change of oil, meaning Haldex out and cleaned inside like new. Then installed back and filled with fresh oil.
Like this (it's for Haldex 4, you (MY2007) have Haldex 3, but it's the same idea):




It's a procedure that, in my opinion, should be performed every 60.000 kms (40.000 miles) for a hassle free motoring...

Post #227125 14th Jun 2014 3:55 pm
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
Freel2.com RSS Feed - All Forums


Switch to Mobile site