Forum-Gallery-Shop-Sponsors

« Advertise on Freel2.com

Home > Technical > Rear Pdc Problem
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
davef



Member Since: 14 Oct 2013
Location: Tyne & Wear
Posts: 10

United Kingdom 2007 Freelander 2 TD4 GS Manual Zermatt Silver
Rear Pdc Problem

My rear sensors stopped working properly the other day, sometimes I get the single tone at start up , other times everything is fine and it works ok, I had it tested on a diagnostic system and came back with rear right inner sensor intermittent fault which I have had changed (looking from the rear) but still get the same fault reading can anybody tell me if it is right looking front to rear or rear to front

Post #222379 17th Apr 2014 2:19 pm
View user's profile Send private message View poster's gallery Reply with quote
pab



Member Since: 28 Aug 2012
Location: Now in Mid-Wales
Posts: 2006

United Kingdom 2009 Freelander 2 TD4 XS Manual Lago Grey

I can't give you the definitive answer, but left and right is normally from the perspective of the driver sitting in the car. Thus on a UK car right is offside and left is nearside. So it sounds as though you changed the correct sensor.

It could be faulty wiring somewhere, or if you're unlucky a fault in whatever box of electronics the sensors connect to.

Post #222380 17th Apr 2014 2:35 pm
View user's profile Send private message View poster's gallery Reply with quote
EYorkshire



Member Since: 18 Nov 2010
Location: (!)
Posts: 4392

That's how I would see it also. Fault code for 'rear right inner' sensor is B1B46-01 so if that was the code it was the correct sensor.

Post #222385 17th Apr 2014 3:10 pm
View user's profile Send private message View poster's gallery Reply with quote
choccymonster



Member Since: 27 Sep 2013
Location: Chichester, West Sussex
Posts: 513

United Kingdom 2007 Freelander 2 TD4 HSE Manual Tambora Flame

Not much help for you I realise, but I have almost exactly the same problem.

Single tone on start up and disabled sensors (front and rear).

Diagnostics shows failed right rear sensor, which has been changed twice to no avail.

Have reconciled that it is the box of electronics in the boot that has had it - just need to source a replacement.

I assume I can just plug in a new control module? Or does it need to be coded to the car?

Post #222390 17th Apr 2014 6:35 pm
View user's profile Send private message View poster's gallery Reply with quote
j00ppis



Member Since: 24 May 2013
Location: Finland
Posts: 198

Finland 
wirings

Check the wirings before touching to parking aid ecu. What year model you got? Ive got 07, and my front pdc stopped working. Fault was on wiring, corrosion. Replaced wiring and all fine.

You find parking aid ecu on rear leff quarter of boot load, under the sidepanel. There is one power pin and front pdc and rear pdc connectors, pending if you have both. But first try change the sensor harness or test it

Post #222425 18th Apr 2014 8:31 am
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
Freel2.com RSS Feed - All Forums


Switch to Mobile site