Afternoon all just fitting a new roof rack and was a bit to heavy handed when taking the rear scrivets out and it ended up snapping i am wondering if it is possible to getthe parts on line but unsure of the name any idea if possible were i can grt them from below is a picture of said part and again it’s located just under the roof strip.

I had a bolt snap off in the outback, 2 different ones on different occasions. No fun a 1000km from anywhere. Made the hole a bit bigger in the roof rail & used an M10 as a temporary measure.

When back home I cut a slot in the snapped off M6 with Dremel (Bosch equivalent (which is better)). Unscrewed M6 without problems.

When putting back all the bolts use some teflon plumbing tape.

The M6 bolts are pretty soft so easy to Dremel, probably on purpose so if the roof rack is over stressed for a longer period, they snap before the bodywork snaps.

I used some M6 316 stainless Allen bolts & washers as replacement with teflon tape, as steel doesn't like stainless steel. Procrastination, mankind's greatest labour saving device!

Acoustic insulation ARB TPMS 3xARB air compressors After cooler Air tank On-board OCD pressure air/water cleaning Additional 50L fuel Carpet in doors ABE 2x1kg Waeco 28L modified fridge Battery 4x26ah Solar 120w Victron MPPT 100/20 DC-DC 18amps 175amp jumper plug Awning 6x255/60R18

Thanks light

Some more information here: https://www.freel2.com/forum/topic35376.html Procrastination, mankind's greatest labour saving device!

Acoustic insulation ARB TPMS 3xARB air compressors After cooler Air tank On-board OCD pressure air/water cleaning Additional 50L fuel Carpet in doors ABE 2x1kg Waeco 28L modified fridge Battery 4x26ah Solar 120w Victron MPPT 100/20 DC-DC 18amps 175amp jumper plug Awning 6x255/60R18

Found out that they are roof studs (part number is LR026326) parts are cheap enough but p&p is a fooker but needs must