Forum-Gallery-Shop-Sponsors

« Advertise on Freel2.com

Home > General > no fourwheel drive
Post Reply  Down to end
Page 1 of 2 12>
Print this entire topic · 
tuneupsteve



Member Since: 14 Feb 2021
Location: sussex
Posts: 3

no fourwheel drive

hi think my 4x4 has stopped working. When i have the engine off but in gear(manual gearbox) I can turn the propshaft,with all four wheels on the ground, is that correct? no faults from the haldex unit and new oil/filter in unit.
Thanks

Post #404062 14th Feb 2021 1:41 pm
View user's profile Send private message View poster's gallery Reply with quote
Dartman the one



Member Since: 04 Apr 2013
Location: Seville, Spain
Posts: 1687

England 

The Haldex unit is at the rear, what you describe is no drive from the transfer box, how much can you turn it? my PC is slightly to the right of Genghis
2012 HSE SD4 In Orkney Grey now gone, best car ever.

Post #404073 14th Feb 2021 6:00 pm
View user's profile Send private message View poster's gallery Reply with quote
Nodge68



Member Since: 15 Jul 2020
Location: Newquay
Posts: 2082

United Kingdom 2009 Freelander 2 TD4 SE Manual Rimini Red
Re: no fourwheel drive

tuneupsteve wrote:
hi think my 4x4 has stopped working. When i have the engine off but in gear(manual gearbox) I can turn the propshaft,with all four wheels on the ground, is that correct? no faults from the haldex unit and new oil/filter in unit.
Thanks


If you can turn the propshaft with only slight resistance and all 4 wheels on the ground, then it points to the splines between the gearbox and PTU being stripped. Hyundai Ioniq 5 Ultimate. The family car.
2009 Rimini Red SE TD4. Gone.
2006 Tonga Green i6 HSE. Gone.
Audi A5 convertible, my daily driver.
1972 Hillman Avenger GT, the project.

Post #404074 14th Feb 2021 6:56 pm
View user's profile Send private message View poster's gallery Reply with quote
tuneupsteve



Member Since: 14 Feb 2021
Location: sussex
Posts: 3

thanks for reply, i can turn it with very little resistance all the way round, I think this happened after mot when they put it on the brake rollers and forgot to set it for 4x4 system and it spun the rear wheels on the concrete, may need a word with the mot station once I have it checked.

Post #404076 14th Feb 2021 8:07 pm
View user's profile Send private message View poster's gallery Reply with quote
3landertwo



Member Since: 27 May 2020
Location: UK
Posts: 1127

I had my car tested only last week, same guy every year. He knows not to put it on the rolling road.

That is why I use a known competent MOT station.

Get down your station and get them to fix it, that's if they agree to liability. ?

Good Luck.

Post #404077 14th Feb 2021 8:17 pm
View user's profile Send private message View poster's gallery Reply with quote
seagull1



Member Since: 23 Jan 2011
Location: Loughborough
Posts: 327

United Kingdom 2007 Freelander 2 TD4 GS Auto Sumatra Black

My MOT station always use a Tapley Brake Test Meter (decelerometer) to test the brakes.

Richard FL2 07 TD4 GS Auto
Ex 02 TD4 Auto

Post #404079 14th Feb 2021 9:26 pm
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
jules



Member Since: 13 Dec 2007
Location: The Wilds of Warwickshire
Posts: 5006

United Kingdom 2014 Freelander 2 SD4 SE Auto Firenze Red

tuneupsteve wrote:
thanks for reply, i can turn it with very little resistance all the way round, I think this happened after mot when they put it on the brake rollers and forgot to set it for 4x4 system and it spun the rear wheels on the concrete, may need a word with the mot station once I have it checked.


Interesting :

I thought the brake rollers did the driving of the wheels rather than the other way round.

What I'd like to know is if the FL2 engine is running with the gearbox is in neutral, and the front wheels are spun up by the brake roller will the system interpret that as "front wheel spin" and engage the haldex causing drive to go through to the rear wheels (just like it does when starting off fast) ?

If the haldex remains disengaged when the gearbox is in neutral then no drive should get through to the rear wheels. If that is the case then I see no problem in using a FL2 on a single axle brake roller - its not permanent 4WD.
Happy to be corrected. Smile Jules

Post #404080 14th Feb 2021 9:35 pm
View user's profile Send private message View poster's gallery Reply with quote
alex_pescaru



Member Since: 12 Mar 2009
Location: RO
Posts: 4642

You're correct.
And more of that, because for brake testing there is little importance for the direction in which the wheel is spinning, if the test rig knows to spin one side (i.e. left) forward and the other side (i.e. right) backwards, then, even if the haldex (or center differential) is locked, no power is transmitted to the other axle, because the movement is "lost" on that (tested) axle differential.

Post #404081 14th Feb 2021 10:45 pm
View user's profile Send private message View poster's gallery Reply with quote
Badger51



Member Since: 01 Mar 2014
Location: Coffs Harbour
Posts: 962

Australia 

More info in this thread re brake testers!

https://www.freel2.com/forum/post239306.html (Now Sold). 2008 Freelander 2 (Nazca Sand) SE TD4 Auto. Statutory write off & on WOVR for hail damage but still road legal.
171037Km as of 09/05/22
Superchips Bluefin Flash
Nanocom Evo II (also sold)

Post #404082 14th Feb 2021 10:54 pm
View user's profile Send private message View poster's gallery Reply with quote
IanMetro



Member Since: 11 Sep 2017
Location: Somerset BS21
Posts: 3127

United Kingdom 2014 Freelander 2 SD4 Metropolis LE Auto Fuji White

There is this note in the handbook on page 216

CAUTION

The vehicle should only be towed in a
forward direction with all four wheels on
the ground. Towing in a reverse direction with
two wheels on the ground will result in serious
damage to the transmission.


The vehicle should only be towed for a
maximum of 80 km (50 miles), at a
maximum speed of 80 km/h (50 mph). Towing
for a greater distance, or at a higher speed may
result in serious damage to the transmission.

http://www.axelzone.ro/car/lr/fl2_handbook_2007.pdf

There is quite a few references on the internet regarding the wisdom of using 2 wheel rolling road testers on 4 wheel drive cars, but I cannot spot an answer from an authoritarian source.

We have MOT testers on this forum, perhaps they will give us the official answer on how to test 4 wheel drive vehicles.

PS oops! I was typing when the 2 previous answers were posted. FL2 XS SD4 Auto 2010 2012-2017 (21k - 91k miles) (MY2011)
FL2 Metropolis SD4 Auto 2014 2017- (16k - 77k+ miles) (MY2015)
Metro in its 11th Year of (Extended) LR Warranty / Full LR Service History
(Expensive, but Trouble/Worry free - hopefully?)

Post #404083 14th Feb 2021 11:05 pm
View user's profile Send private message View poster's gallery Reply with quote
Badger51



Member Since: 01 Mar 2014
Location: Coffs Harbour
Posts: 962

Australia 

IanMetro, Steve D is an MOT tester, see his posts in the link I posted! (Now Sold). 2008 Freelander 2 (Nazca Sand) SE TD4 Auto. Statutory write off & on WOVR for hail damage but still road legal.
171037Km as of 09/05/22
Superchips Bluefin Flash
Nanocom Evo II (also sold)

Post #404084 14th Feb 2021 11:40 pm
View user's profile Send private message View poster's gallery Reply with quote
jules



Member Since: 13 Dec 2007
Location: The Wilds of Warwickshire
Posts: 5006

United Kingdom 2014 Freelander 2 SD4 SE Auto Firenze Red

alex_pescaru wrote:
You're correct.
And more of that, because for brake testing there is little importance for the direction in which the wheel is spinning, if the test rig knows to spin one side (i.e. left) forward and the other side (i.e. right) backwards, then, even if the haldex (or center differential) is locked, no power is transmitted to the other axle, because the movement is "lost" on that (tested) axle differential.


Every day is a school day - I didnt know the rollers could rotate in opposite directions Thumbs Up Jules

Post #404086 15th Feb 2021 12:11 am
View user's profile Send private message View poster's gallery Reply with quote
Scudmonkey



Member Since: 27 Jun 2020
Location: Bettws South Wales
Posts: 27

United Kingdom 2008 Freelander 2 TD4 XS Manual Stornoway Grey

Ahh this explains a few things...
When i bought the car the drivers side Handbrake was completely shot (The shoes actually disintegrated when i took them out for replacement) and yet the car had been MOT'd and passed, so i guess they had used the Tapley meter ?...the pasenger side Handbrake worked just fine
Recently had the car MOT'd and one of the testers came in to check that it was 4x4 and the vehicle was done on the rolling road , i wondered how they could do that with a 4x4 and now i know....

Post #404089 15th Feb 2021 6:10 am
View user's profile Send private message View poster's gallery Reply with quote
IanMetro



Member Since: 11 Sep 2017
Location: Somerset BS21
Posts: 3127

United Kingdom 2014 Freelander 2 SD4 Metropolis LE Auto Fuji White

Alex, Badger, (and Steve D) sorry about missing your posts, I was typing my reply when you posted.

I just thought that 'tuneupsteve' might need some reference information if he is to take up repair costs/damage with garage.

You must remember that I come from a time of brakes worked by rods and/or cables, and you set them up by finding a quite bit of road, and examining the skid marks from jamming on the brakes a few times. FL2 XS SD4 Auto 2010 2012-2017 (21k - 91k miles) (MY2011)
FL2 Metropolis SD4 Auto 2014 2017- (16k - 77k+ miles) (MY2015)
Metro in its 11th Year of (Extended) LR Warranty / Full LR Service History
(Expensive, but Trouble/Worry free - hopefully?)

Post #404120 15th Feb 2021 7:59 pm
View user's profile Send private message View poster's gallery Reply with quote
3landertwo



Member Since: 27 May 2020
Location: UK
Posts: 1127

...... or the method of placing a house hold brick, on it's end, in the passenger's footwell ....... did steve do that as an apprentice. Laughing Laughing

Post #404123 15th Feb 2021 8:35 pm
View user's profile Send private message View poster's gallery Reply with quote
Post Reply  Back to top
Page 1 of 2 12>
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
Freel2.com RSS Feed - All Forums


Switch to Mobile site