Home · FAQ · New Posts · My Posts · PMs · Search · Members · Members Map · Calendar · Profile · Donate · Register · Log In |
Home > Technical > crankshaft position sensors keeps failing |
|
|
Arctic Member Since: 24 Aug 2016 Location: Westmidlands Posts: 561 |
I had a few jobs to do under the FL2 today checking brake lines etc and Hammerite the sub frame, while i have the lower engine under tray off i noticed that you could in fact fit the crankshaft sensor from under the car, save removing the wheel and wheel arch liner.
|
||
5th Aug 2024 10:20 pm |
|
Nodge68 Member Since: 15 Jul 2020 Location: Newquay Posts: 2082 |
I've replaced the crank sensor at the side of the road, twice. The steering needs to be full right, and the splash guard is released from the rear fixing only, then it can be bent downwards out of the way. It took me about 10 minutes to do, but it's not pleasant being at the side of a busy A road, with your legs sticking into the gutter. Hyundai Ioniq 5 Ultimate. The family car.
|
||
6th Aug 2024 10:08 am |
|
Arctic Member Since: 24 Aug 2016 Location: Westmidlands Posts: 561 |
Hi John. Hope you are keeping well and life is treating you good, you are braver than me, but if it calls for it then yes i suppose i would give it a go you have to live dangerously sometime |
||
6th Aug 2024 4:15 pm |
|
Nodge68 Member Since: 15 Jul 2020 Location: Newquay Posts: 2082 |
I'm good, although my Freelander is kicking my butt at the moment.
|
||
6th Aug 2024 6:08 pm |
|
Arctic Member Since: 24 Aug 2016 Location: Westmidlands Posts: 561 |
. The FL2 will certainly keep you on your toes that's for sure, just change my two front back plate, used Irwins tool to undo the bolts due to corrosion replace with some good six sided bolts. 1 Used the smallest 8mm 2 One i had to hammer on a 7mm socket to get it removed. 3 4 5 Good luck with the rest, note the torx screw which was stuck and had to grind it flat, that will need drilling out soon. |
||
7th Aug 2024 12:31 am |
|
Arctic Member Since: 24 Aug 2016 Location: Westmidlands Posts: 561 |
Bringing the thread back up to date about crankshaft sensors, today i was going to purchase another Febi sensor from the same seller, but noted that the sensor only fits up to Chassis No.: AH999999
|
||
21st Aug 2024 1:32 pm |
|
jules Member Since: 13 Dec 2007 Location: The Wilds of Warwickshire Posts: 5063 |
Interesting.
|
||
21st Aug 2024 6:09 pm |
|
|
All times are GMT |
< Previous Topic | Next Topic > |
Posting Rules
|
Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis