Forum-Gallery-Shop-Sponsors

« Advertise on Freel2.com

Home > Search
Search found 7 matches

Author Message
 Heater blower gone bang!
redbenson111

Post11th May 2017 9:58 pm
Forum: General · Replies: 11 · Views: 4555 · Subject: Heater blower gone bang!
I was wondering if I could just change the fan part via the opening in the engine bay. Worth a thought.
 Heater blower gone bang!
redbenson111

Post11th May 2017 7:50 pm
Forum: General · Replies: 11 · Views: 4555 · Subject: Heater blower gone bang!
Thanks for that. I have got the full manual but it is on my other laptop at home so I couldn't check it.

Haynes say take the doors off, take the front seats out, gear selector and surround and dash ...
 Heater blower gone bang!
redbenson111

Post11th May 2017 5:25 pm
Forum: General · Replies: 11 · Views: 4555 · Subject: Heater blower gone bang!
Got a 2008 Freelander 2.

Driving along today and the heater blower started humming. Very quickly it got deafeningly loud and then the whole car started vibrating. Switched the blower off and back ...
 Probably been asked before
redbenson111

Post1st Oct 2016 5:53 pm
Forum: Technical · Replies: 1 · Views: 1415 · Subject: Probably been asked before
This has probably been asked before, but I can't find the answer.

My service indicator used to show for a few seconds after turning on the ignition, but after resetting the indicator after my last ...
 Won't start - timing, fuel, sensors?
redbenson111

Post7th May 2016 8:34 pm
Forum: General · Replies: 6 · Views: 2859 · Subject: Won't start - timing, fuel, sensors?
Thanks for the reply - thats exactly what I've been doing while you were replying and guess what?
It was one notch out.

I guess that I didn't have the tension right on the right hand side of the b ...
 Won't start - timing, fuel, sensors?
redbenson111

Post7th May 2016 4:02 pm
Forum: General · Replies: 6 · Views: 2859 · Subject: Won't start - timing, fuel, sensors?
I should have said - the rev counter is working when it fires up so it shouldn't be the crank sensor.

Is this an interference engine do you know? Could it still run with the belt one tooth out?
 Won't start - timing, fuel, sensors?
redbenson111

Post7th May 2016 3:14 pm
Forum: General · Replies: 6 · Views: 2859 · Subject: Won't start - timing, fuel, sensors?
Just changed the timing belt on my 2008 TD4. 180,000miles so it was probably living on borrowed time.

Used all the correct procedures – locking pins, flywheel lock etc. Belt change went smoothly. D ...
 
All times are GMT

Jump to  
Page 1 of 1



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
Freel2.com RSS Feed - All Forums


Switch to Mobile site