Damn I like this! A set to match the other pillars would be great. FL2, TD4 HSE
The flaming Orange!

andyrussell wrote:

I like that a lot !!!, I'm getting it done

Haha MSPaint!


Admin note: this post has had its images recovered from a money grabbing photo hosting site and reinstated  FL2, TD4 HSE
The flaming Orange!

I've now had a look at this and I will have to firstly say, it's not easy,
but it can be done with a little care and time.

The Kit:

4 sections of matt black vinyl to match the vinyl between the
front and rear doors, over sized and in need of final trim.
1 Plastic Squeeee
1 Felt Squeegee
1 Craft Knife
1 Small Liquid Mist Bottle

Quick installation instructions:

Firstly made sure that all four areas to be covered are clean,
this is very important.

Start on the area to be covered on the rear door
( this section of vinyl is over sized and will need to be trimmed )
The rubber trim around the glass will need to be lifted so the vinyl
can sit under it for a better fit & finish. The other side is to be
wrapped around the inside edge of the door by around 10mm.

The back section:

Firstly remove very carefully the Land Rover oval,
( this is held in place by double sided tape )
be very carefull not to mark the paint work or brake
the plastic oval as a new one will cost around £12 from the dealer.

Lift the rubber seal from around the inside edge of the rear door,
this is again stuck down and will need re-sticking at the end.
Apply vinyl, again over sized for trimming. Very carefully trim with
craft knife around the edge of the rear window rubber.

When the vinyl is applied and dry replace the oval and re-stick
the rubber down over the vinyl for a neat finish.

If you fancy giving it ago ??? remember it will take a lot of care
and a little time but a super finish can be achieved.

The kit price is £35.00 plus £3.95 P+P

Included in this price is a £2.50 site donation from each kit !!

We will also include a full step by step instruction sheet.

Great! Hope you can find a way to send a kit to Norway aswell?  FL2, TD4 HSE
The flaming Orange!

Is it a case of having surgical skills when trimming, how do you not cut into the paint?

No, no surgical skills required, just be careful and precise.
The two forward edges will be hiden, one under the rubber
door seal and the other under the window rubber so both
can be a little longer to aid trimming.

The two rear edges, one will be one the inside of the rear
door, wrapped round so can be a little longer.
The rear most edge will be upto the
rear window seal so care will be needed.

Remember, take your time, it's not a race.

You will not cut into the paint, the cuting will be done
when the vinyl is held away from the paint.

As stated earlier it's no walk in the park to fit, but
with a little care, skill and time it's not that bad.

What more can I say..

and will you ship me a set to Norway...?  FL2, TD4 HSE
The flaming Orange!

Can you tell me how much it is to send the kit to Belgium?
I like it very much....

Redlabel /Bakker911,

Yes we'll send to Europe, after a quick check I
think it will be around £11.00 p+p

do you guys fit it and if so what will you charge ta

Sorry andw, we can not offer a fitting service.

I want a kit as well. Shipped to Norway. Can't leave Redlabel alone with a blackened out C-pillar on a Tambora Flame FL2... Leopard tank drivers never stop at anything.

2007 TD4 HSE Moon Roof Ebony Leather Navi...

can the OP and/or TwoDogs post up close up pictures of the vinyl fitted

its looks OK from afair but would like to see how it fitting/lines are close up around the windows etc Former Mod/Member, with the most post & Chicken George Arch nemesis

Split the topics and set up a sign up in the events section

http://www.freel2.com/forum/post86674.html#86674

For some reason its the only place a sign up can be setup  Former Mod/Member, with the most post & Chicken George Arch nemesis