I have a 2013 plate Freelander 2 TD4 S 2.2.
With regards to the rear seat, I can pull the smaller section up and forward using the tab that sticks up at the back, but when I try to lift the larger section it seems to be fastened underneath at a point in the centre of the car.
I can’t see any sort of release lever and the manual I have downloaded says that the seat should just lift
by pulling the tab.

Am I missing something obvious or do I have to use some hefty brute force?
Thanks

The seat base has a rather strong plastic clip that holds it down have some weetabix and give it a good pull will probably break the plastic clip but not needed anyway, 2013 FL2 XS.
Defender 90 300 TDi.
Defender 90 300 TDi CSW.
1964 MGB Roadster.
1944 Willys MB "Jeep" with bullet holes. (gone)
17 hand Irish Drought Thoroughbred (mostly lame)
Nagging Old Boiler.

Mahatma Gandhi said if there is an Idiot in power those who elected him are well represented. The Enemy is our own corrupt Government.

I had issues for a long time with both seats so I took both plastic clips out to prevent any broken fingers trying to release them. You might need weetabix and a bowl of porridge but they will release

Thanks for the info. I had three weetabix, some porridge and topped it off with some spinach and have
managed to get the seat free 😃👍

Spinach was the ticket! Guaranteed!