Anyone know where and which fuse I’m looking for that controls the Bluetooth & sat nav … 2013 fl2 sd4

My Owners Handbook doesnt mention bluetooth or satnav specifically but lists several fuses in the luggage compartment fuse box for "audio system", digital radio" and "audio amplifier". Jules

Hi , I heard a click noise come from the rear inside boot area of the car when I was reversing and immediately my sat nav and Bluetooth stopped working , everything else works fine radio ect.. any ideas please.. fl2 2013 sd4 thanks .. so presume it’s a fuse.

Have you an Owners Handbook ?

Mine says fuses FD1, FD2, FD3, FD10 AND FD11 But I'd have thought that if it was any of these then then all would go down.

So maybe you need to check the wiring - anything loose in the boot causing a short ?

The wiring diagrams for FL2 are available along with the JLR workshop manual for free from this forum .
Trouble is it only runs up to 2012, and there were substantial changes in certain areas for subsequent models as JLR combined the Evoque wiring looms into later FL2s.

https://www.freel2.com/forum/topic10621.html Jules

Ive got the whole workshop manual downloaded onto my PC and it has wiring diagrams included.
Page 3164 shows the Sat Nav unit wiring.

It looks like the Sat Nav takes power via fuse FD1, 10 amps. Jules

Hi jules ‘ I don’t think I worded it correctly there is power to the sat nav but just says unamed road and initialising’ was working perfectly before I heard the click noise ‘ same with phone it’s lit up on screen but won’t connect my phone, same again my phone was connected to it via Bluetooth before the click noise’

I'm afraid I'm out of ideas.  Jules

A diagnostic is needed to identify the issue. Hyundai Ioniq 5 Ultimate. The family car.
2009 Rimini Red SE TD4. Gone.
2006 Tonga Green i6 HSE. Gone.
Audi A5 convertible, my daily driver.
1972 Hillman Avenger GT, the project.

Yea had that done not picking up any faults.

Fuses here

It sounds that your Radio Receiver or DAB Module have blown they are in the area above the rear wheel arches

Yea someone else said that.. they said I probably need a new Bluetooth ecu/module which is located in right hand side of boot .. that sound about right what the problem could be.

On what side of the boot did you hear the click

I’m not sure which side the noise come from.

Then as previously mentioned you need to run a code reader. Second hand modules are available from breakers but you need to know what the problem is