I’m fitting a light bar to my 2013 LR2 I’ve installed a loom with relay and a “override” switch in the control feed that will come from the main beam. My problem is try as I might I can’t find the main bean live cable on the back of the headlight module.
Anybody help with the cable colour ?

If it doesn't have main beam bulbs, then you'll need to use the feed for the shutter, but I don't know what colour the wires are you need. It's best to put a reverse blocking diode across the relay coil terminals. Hyundai Ioniq 5 Ultimate. The family car.
2009 Rimini Red SE TD4. Gone.
2006 Tonga Green i6 HSE. Gone.
Audi A5 convertible, my daily driver.
1972 Hillman Avenger GT, the project.

Hey thanks

It does have main beam bulbs

Check this out

https://www.freel2.com/forum/topic2943.html

Brilliant many thanks

Nope still can't my lighter to work with the main beam any ideas out there ?

Can you post up a pic of the FRONT of the headlamp. 2013 it will likely (should) have the DRL where the main beam previously sat pre-facelift. That's what Nodge was referring to when he said "you don't have a main beam bulb" as for that headlight you have a single bulb that changes beam throw using a shutter in the projector assembly. Pre face-lift there was a dedicated full beam bulb and that worked in the traditional way (i.e. 12v+ in, lamp lights) while the shutter control is..... more complex than that.

Once we've confirmed the lamp you have then we can work back from there. Current driveway contents:
2021 V60 Cross Country B5
2009 FL2 dog bus and shooting wagon

On Order: 2023 Fisker Ocean Ultra - deposit paid.