Home · FAQ · New Posts · My Posts · PMs · Search · Members · Members Map · Calendar · Profile · Donate · Register · Log In |
Home > General > JLR Manual Download |
|
|
I Like Chips Member Since: 25 Jun 2017 Location: Ascott Under Wychwood Posts: 1545 |
|||
5th Sep 2022 8:21 pm |
|
jules Member Since: 13 Dec 2007 Location: The Wilds of Warwickshire Posts: 5062 |
The pics and descriptions about how things work are much better than the Haynes manual. Jules |
||
5th Sep 2022 9:17 pm |
|
Control Member Since: 16 Feb 2020 Location: South Yorkshire Posts: 16 |
Thanks for that. Much better than Haynes. I now have a fuller understanding of the in tank pump and the fueling system.
|
||
8th Sep 2022 3:20 pm |
|
PRadd Member Since: 09 Apr 2020 Location: East Lancs Posts: 366 |
Probably better to ask in your other thread "broken again" relating to your issue 2014 Freelander 2 TD4 Manual Dynamic
|
||
8th Sep 2022 4:17 pm |
|
Jagracer Member Since: 22 Feb 2019 Location: east anglia Posts: 198 |
Hi, I had trouble priming one of our FL2's. After much wading through peoples thoughts, I found that the tank pump only shifts fuel from one side to the other over the propshaft hump. So if the fuel stops at half a tank full, then look there. The high pressure fuel pump on the engine draws fuel upwards out of the tank, so needs a vacuum proof suction pipe from tank to filter. (front of engine). Ford, in their engines, have a low pressure lift pump in some applications, so one can get confused. The tank has a wiring loom that can give trouble, and sometimes the heat off of the exhaust will melt the wire from tank to ECU if it is too close to it, or abrade through against the heat shield. The pump running is not related to it pushing fuel to the engine. Force fuel through the filter to prime the system, even cracking the injector pipes to be sure that fuel is at the injectors. LR say not to, but I have had no problems doing it, just be aware of the pressure, and only do it when the engine is not running. Once the engine is running, it will draw fuel until the tank is empty. I would also check that you do not have a hole in the fuel pipes where they run past the pulleys on the righthand side of the engine. It is easy to displace them and get them to rub throught on the engine pulley when the Cambelt is changed. Take the offside under wing covers off to check. If the temperature sensor in the tank wiring loom is faulty it stops the ECU reading fuel needs correctly. |
||
9th Sep 2022 3:00 pm |
|
|
All times are GMT |
< Previous Topic | Next Topic > |
Posting Rules
|
Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis