Hi folks!

I'm planning to use SDD with Mongoose Clone to have it just in case

Read about the "EngeneeringMode" (softwaredownload.htm) and like to know, if in this mode a faultcode read/erase and showing PID's is possible? Unfortunetly i have no interface jet so cannot test..


Trying to activate SDD with no success because of the "expired in 1 day" (SDD v155) but will try further..

Sorry because of the "beginners question"

regards, günther

no one?

Well, at the moment I'm playing around with my new Foxwell NT520. I like it to 90%. It shows 7Digit Error codes on (22?) Moduls and has a lot of Service funktions (38?).

Yesterday I'm doing a DPF regeneration while driving. When I'm starting the function, the display in the car show's "DPF full", so it seams to work, but the NT520 shows no PID of "soot charge" etc., so it's hard to tell, if the regeneration completed succesfully...

"Transmission adaption clear" didn't work but maybe its because of low battery voltage...it seems I need a good power supply too. I have one but with only 16A...don't know if it's sufficient. Haven't tried so far...