Forum-Gallery-Shop-Sponsors

« Advertise on Freel2.com

Home > Technical > Freelander 2 2007 diesel manual - message appearing on dash
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
Christine



Member Since: 27 Nov 2018
Location: Fife
Posts: 8

United Kingdom 
Freelander 2 2007 diesel manual - message appearing on dash

Can anyone advise me re a message appearing on my Freelander 2 2007 which says transmission fault traction reduced. this message appears not long after starting. Many thanks for any help here, I have not owned the vehicle for long.

Post #361149 27th Nov 2018 1:10 pm
View user's profile Send private message View poster's gallery Reply with quote
Andy131



Member Since: 09 Dec 2009
Location: Manchester
Posts: 2184

United Kingdom 

Unfortunately you really do need to get the codes read, and not by a basic OBDII reader as these only read engine / emissions related codes.

It can be something as simple as a faulty ABS wheel sensor, or it could be something as expensive as a failing Haldex unit.
A failing battery will also throw up random faults even though it starts the car OK. Tangiers Orange - gone, missing her
Replaced by Ewok what a mistake - now a happy Disco Sport owner

Post #361150 27th Nov 2018 1:14 pm
View user's profile Send private message View poster's gallery Reply with quote
ReggiePerrin



Member Since: 13 Mar 2013
Location: Derbyshire
Posts: 1273

England 2013 Freelander 2 SD4 HSE Lux Auto Firenze Red

I was getting the same (amber warning) message that appeared almost immediately after starting and remained lit until shut down. I had no gearbox programmes available but the car drove quite normally (2WD) whilst the warning was illuminated.

At the same I had a totally inoperative n/s front door lock module... I tried to repair it by cleaning up the motors and when I reinstalled that it still didn't work properly but the gearbox fault warning became much less immediate...

I then fitted a shiny new lock module which cured the locking problem but even better, much much better in fact, the gearbox fault warning instantly disappeared and hasn't been seen since.

The car is driving delightfully, the gearbox programmes are all active and I have all my fingers crossed as I say that. To me there is no rhyme or reason to some of these warnings Question

Post #361168 27th Nov 2018 6:01 pm
View user's profile Send private message View poster's gallery Reply with quote
mjtemple



Member Since: 02 Jun 2016
Location: Leeds
Posts: 75

United Kingdom 2007 Freelander 2 TD4 XS Manual Sumatra Black

As mentioned, for a proper check you need to get the vehicle plugged in, however worth a try in between now and getting it plugged in, charge the battery to rule out a low battery which does throw up messages sometimes. 2007 TD4 XS Manual in Sumatra Black

Post #361279 29th Nov 2018 3:37 pm
View user's profile Send private message View poster's gallery Reply with quote
Ct8637



Member Since: 06 Jan 2017
Location: North Yorkshire
Posts: 115

United Kingdom 2007 Freelander 2 TD4 SE Manual Santorini Black

I had this issue when I had a failing wheel bearing. Rectified once the bearing was replaced. As said you really need a garage to read the codes.

Please update us once you find out what the problem is as it may help somebody else

Post #361741 9th Dec 2018 4:40 pm
View user's profile Send private message View poster's gallery Reply with quote
Christine



Member Since: 27 Nov 2018
Location: Fife
Posts: 8

United Kingdom 

Thank you for your suggestion. I will let you know when the problem is rectified

Post #361824 11th Dec 2018 1:14 pm
View user's profile Send private message View poster's gallery Reply with quote
SYFL2



Member Since: 16 Jun 2012
Location: Sheffield
Posts: 2594

2007 Freelander 2 TD4 HSE Auto Stornoway Grey

Also you should check if the car has the extra earth cable fitted I used to get that message until I fitted a good quality cable.

Post #361828 11th Dec 2018 1:42 pm
View user's profile Send private message View poster's gallery Reply with quote
Christine



Member Since: 27 Nov 2018
Location: Fife
Posts: 8

United Kingdom 

Thank you so much for your help here. I will have this checked out.

Post #361829 11th Dec 2018 1:49 pm
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
Freel2.com RSS Feed - All Forums


Switch to Mobile site