good day all, hoping somone be able to tell me what is the correct settings on tightening the crank pulley

I am planning a timing belt change and have seen many different references to tigtening.

I have a Feelander 2, year 2007 2.2 Desiel engine, engine type 224DT.

I've seen settings like 70Nm, 60Nm, plus the degree tool of 60 degrees and 82 degrees.

I am assuming that i should be using 70Nm + 82 degree?

If someone can confirm for me, be very much appreciated! .

Kind regards, Simon

According to the Haynes manual it's 70Nm followed by 82deg. but the Official workshop manual gives 70Nm followed by 60deg.

Thanks JonMs, much appreciated. Hmm might need to do the old heads or tails decider!