Forum-Gallery-Shop-Sponsors

« Advertise on Freel2.com

Home > United Kingdom > key fob dead and car wont start
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
trev74



Member Since: 15 Feb 2018
Location: moray
Posts: 42

United Kingdom 2010 Freelander 2 TD4 GS Manual Stornoway Grey
key fob dead and car wont start

hi guys,
I cannot see anything related so I hope I can get some advice here,
I know I need to buy a new battery and fob but I have a more immediate problem
I was out last night and went to go to the landi and the doors would not open, (dead keyfob batt, not car batt_
so I used the emergency key and got in via passengers side and opened the car.
but when I put the fob in the slot and pressed the stop/start button, nothing happened. the fob was fully in and I ejected it and put in again with still no results, not dash lights and not starting, (yes my foot was on clutch)
I know the battery is dead but would that stop me from starting?
I did get a tow home but need my landi asap.
I put a Haynes and wow and Delphi diagnostic on it but no codes.
any suggestions apart from dead batt?
thanks

Post #358870 17th Oct 2018 2:37 pm
View user's profile Send private message View poster's gallery Reply with quote
Yorky Bob



Member Since: 28 Apr 2015
Location: Yorkshire
Posts: 4561

United Kingdom 2013 Freelander 2 TD4 GS Manual Firenze Red

and the second spare fob did what ? FL2 MY10 TD4 GS traded in at 2 years
FL2 MY13 TD4 GS Current

Post #358875 17th Oct 2018 3:33 pm
View user's profile Send private message View poster's gallery Reply with quote
pab



Member Since: 28 Aug 2012
Location: Now in Mid-Wales
Posts: 2007

United Kingdom 2009 Freelander 2 TD4 XS Manual Lago Grey
Re: key fob dead and car wont start

trev74 wrote:

I know the battery is dead but would that stop me from starting?

No, it should not. Battery power (in the fob) is not needed for starting and the immobilizer chip is completely separate from the remote control circuitry.

Are you sure the car battery is OK and something didn't run it flat whilst it was parked? That can happen with the FL2 - and indeed happened to me only last week!

Post #358880 17th Oct 2018 4:04 pm
View user's profile Send private message View poster's gallery Reply with quote
trev74



Member Since: 15 Feb 2018
Location: moray
Posts: 42

United Kingdom 2010 Freelander 2 TD4 GS Manual Stornoway Grey

I don't have a 2nd fob as the wife lost it several months ago when she lost her bag.
the Battery is new, only about 3 month old and bought from landrover dealership at £225. I took battery to them dealers this afternoon to be safe and they checked it and said nothing was wrong with it, it had a full charge.
I have put it back in car and still same issue.
checked every fuse I can find and all ok.
ive googled the problem but have not found anything usefull

Post #358889 17th Oct 2018 5:13 pm
View user's profile Send private message View poster's gallery Reply with quote
shiggsy



Member Since: 13 Jan 2013
Location: Kent
Posts: 799

United Kingdom 2007 Freelander 2 TD4 HSE Auto Baltic Blue

Did the alarm go off when you used the fob key to get into the vehicle ?
Which fuse locations did you check?
You have no electrical signs of life from the vehicle at all ?
Do you have your own multi meter ?

It certainly sounds like the vehicles battery power is not getting to the vehicle, like it got a complete break in the batteries main power or earth cable. 
Hung like Einstein, smart as a horse.

Post #358893 17th Oct 2018 6:46 pm
View user's profile Send private message View poster's gallery Reply with quote
Yorky Bob



Member Since: 28 Apr 2015
Location: Yorkshire
Posts: 4561

United Kingdom 2013 Freelander 2 TD4 GS Manual Firenze Red

So go back a stage. Do you have any power to anything like lights, interior lights, radio ? FL2 MY10 TD4 GS traded in at 2 years
FL2 MY13 TD4 GS Current

Post #358894 17th Oct 2018 6:55 pm
View user's profile Send private message View poster's gallery Reply with quote
IanMetro



Member Since: 11 Sep 2017
Location: Somerset BS21
Posts: 3126

United Kingdom 2014 Freelander 2 SD4 Metropolis LE Auto Fuji White

The Repair Manual seems to indicate that your key is no longer programmed, or is unserviceable.
I have used the emergency key a couple of times (after leaving it for a long time at Heathrow) in my first FL2, and the car sprung into life immediately the Remote Key was inserted in slot.

Or as Bob says a dead main battery / blown fuse.

Inspection and Verification
The best method to confirm the correct operation of the Passive Anti-Theft System (PATS) is to check the LED (located in the center of the instrument panel). The LED should illuminate solid for 3 seconds, when the ignition status is set to ON, and then extinguish. This validates all PATS functions (i.e. the key transponder matches a stored key code, the challenge/response sequence between the respective modules was successful resulting in the EMS being enabled).

Ignition Fails to Operate
Check that the key is correctly inserted into the start control unit (SCU) and that it is the correct key for the vehicle (Key will be ejected from the SCU if it is not programmed or from another vehicle). If the vehicle is an automatic, ensure that the Park position is selected and if manual, ensure it is in the Neutral position. Check that the start button circuit to the Central Junction Box (CJB) is not open circuit or short to ground. Check that the CAN network is not malfunctioning, i.e. open circuit or short circuit. This would mean that the CJB, ECM and Instrument Cluster would be unable to communicate. Check these modules for related DTCs and refer to relevant DTC Index.
 FL2 XS SD4 Auto 2010 2012-2017 (21k - 91k miles) (MY2011)
FL2 Metropolis SD4 Auto 2014 2017- (16k - 77k+ miles) (MY2015)
Metro in its 11th Year of (Extended) LR Warranty / Full LR Service History
(Expensive, but Trouble/Worry free - hopefully?)

Post #358898 17th Oct 2018 10:38 pm
View user's profile Send private message View poster's gallery Reply with quote
trev74



Member Since: 15 Feb 2018
Location: moray
Posts: 42

United Kingdom 2010 Freelander 2 TD4 GS Manual Stornoway Grey

Sorry got called away due to family emergency,
I cannot recall off hand if I had power inside the car, I just wanted home. Im back home later today/tomorrow and will have a look.

Yorky Bob wrote:
So go back a stage. Do you have any power to anything like lights, interior lights, radio ?

Post #359414 26th Oct 2018 10:34 am
View user's profile Send private message View poster's gallery Reply with quote
trev74



Member Since: 15 Feb 2018
Location: moray
Posts: 42

United Kingdom 2010 Freelander 2 TD4 GS Manual Stornoway Grey

I have software to reprogram keys if needed so no issue there hopefully.
im going to check the landi tomorrow and see if I have power in the car, all fuses are intact that I can see but will double check again
main batt is fine and been on a optimizer since I got it home.
I know internal lights come on
Will update tomorrow

IanMetro wrote:
The Repair Manual seems to indicate that your key is no longer programmed, or is unserviceable.
I have used the emergency key a couple of times (after leaving it for a long time at Heathrow) in my first FL2, and the car sprung into life immediately the Remote Key was inserted in slot.

Or as Bob says a dead main battery / blown fuse.

Inspection and Verification
The best method to confirm the correct operation of the Passive Anti-Theft System (PATS) is to check the LED (located in the center of the instrument panel). The LED should illuminate solid for 3 seconds, when the ignition status is set to ON, and then extinguish. This validates all PATS functions (i.e. the key transponder matches a stored key code, the challenge/response sequence between the respective modules was successful resulting in the EMS being enabled).

Ignition Fails to Operate
Check that the key is correctly inserted into the start control unit (SCU) and that it is the correct key for the vehicle (Key will be ejected from the SCU if it is not programmed or from another vehicle). If the vehicle is an automatic, ensure that the Park position is selected and if manual, ensure it is in the Neutral position. Check that the start button circuit to the Central Junction Box (CJB) is not open circuit or short to ground. Check that the CAN network is not malfunctioning, i.e. open circuit or short circuit. This would mean that the CJB, ECM and Instrument Cluster would be unable to communicate. Check these modules for related DTCs and refer to relevant DTC Index.

Post #359416 26th Oct 2018 10:38 am
View user's profile Send private message View poster's gallery Reply with quote
Steve D



Member Since: 19 Jan 2013
Location: Essexshire
Posts: 4109

United Kingdom 

Don’t these have connectors under the front passenger carpet area? IIRC, these can be easily disconnected. Past: FL2 TD4 HSE Auto
Evoque SD4 Dynamic Lux Auto
Present: Audi A3 S Line.

Post #359435 26th Oct 2018 3:49 pm
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
Freel2.com RSS Feed - All Forums


Switch to Mobile site