Former Mod/Member, with the most post & Chicken George Arch nemesis

Is there a way to search Ebay for 'Freelander 2' without getting all the freelander 2.0's?


edit. I went into advanced search and excluded 2.0 with some success  At work
At home

"I can't always believe facts I read on the web" - Charles Dickens

winner by default of the tractor vs caravan race

Last edited by chicken george on 31st Aug 2008 9:04 pm. Edited 1 time in total

i've not come across one

Stopped looking on eBay now for the FL2 bargins

99p and a full set of the black plastic side skirts taking up the room in the garage, but they make the car well looked after when i come to swapping it  Former Mod/Member, with the most post & Chicken George Arch nemesis

I don't use ebay I use NPbay, where the parts and postage are free!!  Once you've tasted GREY you'll never go back!

chicken george wrote:

Is there a way to search Ebay for 'Freelander 2' without getting all the freelander 2.0's?


edit. I went into advanced search and excluded 2.0 with some success

does the trick At work
At home

"I can't always believe facts I read on the web" - Charles Dickens

winner by default of the tractor vs caravan race

Anyone know how long it takes for the 3M adhesive / tape cure? I was thinking that 24 hours should be sufficient even perhaps a little less? - anyone had any additional trim fitted by a dealer and if so how long was ti before you could drive the car again (npinks, didn't you have your spoiler fitted by the dealer? - if so did you drop off and pick up on the same day?)

Just picked up the sport kit from Hereford Landrover and weather permitting was hoping to fit it tomorrow, however i will need the car back on the road by Monday morning for work!

Any ideas?

Just hope i don't screw up the fitting

I had my side tubes fitted by the dealer, same day 1 hour labour (£68 )

My spoiler is still the be purchased at some time or another,  Former Mod/Member, with the most post & Chicken George Arch nemesis

Saw the local black fl2 with sports kit again yesterday..looked a lot better than I remembered (maybe because it was p ssing it down and I couldn't see for properly ? also it was looking clean for once its normally absolutely filthy) At work
At home

"I can't always believe facts I read on the web" - Charles Dickens

winner by default of the tractor vs caravan race

CG... let me get some pictures up once i've fitted the kit... it'll change your mind fella

upside down parts and 3m tape hanging out all over  At work
At home

"I can't always believe facts I read on the web" - Charles Dickens

winner by default of the tractor vs caravan race

Yeah that's about right!

Something missing!

Click image to enlarge

Nice saw job. Would like to see pic of the finished project.

How did the new grill go in and did you have to shave the sides down any more, as the edges of the old grill seem to stick out still?

I would like to change mine, just plucking up the courage to make the first cut! FL2 TD4 XS Santorini

The new grill fitted in just fine - it wraps the whole of the old grill, so you can't see any of the old silver grill (and cuts), even if you look through the 'grill' part.
The cuts were to make ok, just took a little while with a hack saw blade with a improvised handle of gaffa tape! The cuts don't need to be flush (at least on the sides) as there is a cavity (3 to 5 mm) on the inside of the new grill - Then just clean the surface of the old grill, apply the resin adhesive, which is dead easy as it comes with a handy little applicator sponge in the sachet, line up the new grill and then just pull the back of the 3M tape off - and hey presto, 1 HST / sports kit grill...

Will post a pic tomorrow sometime - quality is not great as it's from my iphone... can't believe it still only has a 2mp camera