snappa wrote:

There are times you just need to move the car 20 feet or so and the chiming does my nut in

Not any more though!

summers wrote:

Sorted it out with the Auto and keyless fob. Insert fob and start the car in the normal way and then stall it - the ignition lights remain on and then you can do the operation with the seat belt 10 times within the minute. Worked fine - silence is bliss!!

summers wrote:

This worked fine for me on my Disco 3 but I am having problems achieving it on the FL2. How do you get the ignition on with the keyless fob?

When you insert the fob the radio works but there is no warning lights etc until you press the start button.

Any help would be much appreciated.

Peter

another auto FL2 is now chimeless!!!!!  Now - 2017 BMW X3 M Sport Carbon Black
Gone - 2014 BMW X3 M Sport Space Grey, faultless!
Gone - 2011 Freelander 2 SD4 HSE Bali Blue with xenons
Gone - 2008 Freelander 2 TD4 HSE Rimini Red with bodykit

Next task 'how to silence Npinks?'  At work
At home

"I can't always believe facts I read on the web" - Charles Dickens

winner by default of the tractor vs caravan race

chicken george wrote:

Next task 'how to silence Npinks?'

i thought this section was 'tips & tricks' not 'curing the impossible'  Now - 2017 BMW X3 M Sport Carbon Black
Gone - 2014 BMW X3 M Sport Space Grey, faultless!
Gone - 2011 Freelander 2 SD4 HSE Bali Blue with xenons
Gone - 2008 Freelander 2 TD4 HSE Rimini Red with bodykit

Thank you for this tip worked a treat!

Yes, thanks, that's a lot quieter now.

Is there any way of silencing the door open bong, when the key's still in?

take the key out

Sorry couldn't resist, I've not heard of a cure for that one yet Former Mod/Member, with the most post & Chicken George Arch nemesis

or close the door  2007 Freelander 2 HSE TD4 Manual with Premium Pack & Moonroof.
Stornoway Grey with Ebony Black Pleather, Clear Indicators, Body Side Mouldings etc.

Can get this seatbelt thingy to work on mine no matter how many times I insert it

Also, just had new rear passenger door but can't get the one touch function on the window to work properly, tis ok going down but won't one touch up.............anyone any ideas  ______________________
2011 Full Fat RR 4.4 TDV8
2012 FL2 SD4 Auto HSE
2013 Kawasaki Versys 650

Dave wrote:

Also, just had new rear passenger door but can't get the one touch function on the window to work properly, tis ok going down but won't one touch up.............anyone any ideas

Either reset the window or use silicon to lubricate the window seal the window may be a bit tight.
where did your old door go, did you leave it in a pub or something? At work
At home

"I can't always believe facts I read on the web" - Charles Dickens

winner by default of the tractor vs caravan race

Quote:

Can get this seatbelt thingy to work on mine no matter how many times I insert it

Presume that's can't ? Was the ignition switched on but engine not running? 

Quote:

Presume that's can't ? Was the ignition switched on but engine not running?

Ooops sorry yes, it's POETS day so brain isn't engaged

And yes to your second question too.

CG, door been replaced after some nice T T put a dent in it in a carpark and didn't even leave a note to say sorry B D ______________________
2011 Full Fat RR 4.4 TDV8
2012 FL2 SD4 Auto HSE
2013 Kawasaki Versys 650

The procedure I did was this:

open car
sit in drivers seat
key in ignition
press and hold down start button (foot NOT on clutch) until lights on dash come on
put seat belt in and out 10 times (I only counted 9 ) until a bleep

Job done