Dear YF,

I just found you mentioned "LTB00088" been skip by the following:
What's wrong with my previliage for that web?

R/Charvis


Interior Odor / DTC B102E-11 Stored - Repair Procedure To subscribe to view this document click here
Reference: LTB00134NASF (1) Folder: 412 - Climate Control System

--------------------------------------------------------------------------------
Roof Opening Panel Misaligned / Jammed - Repair Procedure To subscribe to view this document click here
Reference: LTB00117NASF (1) Folder: 501 - Body System

--------------------------------------------------------------------------------
Loss of Audio System Sound on Start-up – Repair Procedure To subscribe to view this document click here
Reference: LTB00096NASF (1) Folder: 415 - Entertainment System

--------------------------------------------------------------------------------
Poor Starting/Stumble on Start-up – Repair Procedure To subscribe to view this document click here
Reference: LTB00094NASF (1) Folder: 310 - Fuel System

--------------------------------------------------------------------------------
Intermittent No-Start and Trip Function Resets to Zero – Repair Procedure To subscribe to view this document click here
Reference: LTB00093NASF (1) Folder: 310 - Fuel System

--------------------------------------------------------------------------------
Interior Rear View Mirror Mounting Boss – Installation To subscribe to view this document click here
Reference: LTB00089NASF (1) Folder: 501 - Body System

--------------------------------------------------------------------------------
Parking Brake Adjustment To subscribe to view this document click here
Reference: LTB00086NASF (1) Folder: 206 - Brake System

--------------------------------------------------------------------------------
Windshield Wiper Blades Knocking/Juddering - Diagnostic Procedure To subscribe to view this document click here
Reference: LTB00085NASF (1) Folder: 501 - Body System

--------------------------------------------------------------------------------
Starter Breather Extension for Arduous Use Vehicles To subscribe to view this document click here
Reference: LTB00073NASF (1) Folder: 303 - Engine System

--------------------------------------------------------------------------------
Knocking Noise from Front Suspension To subscribe to view this document click here
Reference: LTB00055NASF (1) Folder: 204 - Suspension System

--------------------------------------------------------------------------------
Rear Suspension Noise To subscribe to view this document click here
Reference: LTB00048NAS4 (4) Folder: 204 - Suspension System

--------------------------------------------------------------------------------
Exterior Paint Defect Reporting To subscribe to view this document click here
Reference: LTB00046NASF (1) Folder: 501 - Body System

--------------------------------------------------------------------------------
Doors Require Greater Opening Effort in Very Cold Weather To subscribe to view this document click here
Reference: LTB00040NASF (1) Folder: 501 - Body System

--------------------------------------------------------------------------------
Windshield Wiper Noise, Judder or Streaking - Cleaning Procedure To subscribe to view this document click here
Reference: LRA501-002NASF (1) Folder: 501 - Body System New one is not the better one!

Dear Charvis, I do not know. Maybe you are on the wrong Bulletins with regard to related continent. I do not know if in your country the DPF is standard or an extra option. It it is an extra option, Landrover has probably very little experience with DPF performance in your country (as this is the case in general!!!).
So try to look into the techn. bulletins for Europe, as DPF in England is an option and hardly ordered.

YF

Chavis, I have checked the LR Service Publications once again, and my reference is correct.
If you are on the Owner Info-site, your choose "rest of the world" and register.
Then you have a variety of options, choose "Service Bulletins" and/or "service actions".
Here you will find under reference no. QO24 EX "incorrect emmission calibration level".
You MUST find this site, if you follow my guidance.

YF

Hello YF,

Thanks for your answer on this subject.

The only thing that keeps me busy is the situation when off roading and a cleaning cycle is requiered but due to terrain not possible to have 1700 rpm during at least 5to7 min?

regards Albert Frederik.

Dear YF,

Thank you very much for your kind instructions! I did find the bulletin-LTB00088 already.

There is no any sensor replacement description in it. Would you please help me to verify this proposal is true or not?

Refer to:

"Technical Service Bulletin
No.LTB00088
24 September 2007

Subject/Concern: Reduced Power With the Possibility of DTC P0299 Stored

Models:
Freelander 2/LR2 (LF) TD4 (DPF) Automatic Only
TD4 (DPF) Automatic Only VIN-range: 000201-H062156


Markets: All

Section: 419-10

Summary:
The instrument pack displays a message 'reduced power' and the vehicle goes into limp home mode, with the possibility of Diagnostic Trouble Code (DTC) P0299 stored.

Cause: Incorrect diagnostic calibration. Suggested Customer Concern Code - E29.
Action: Should a customer express concern, re-configure the Engine Control Module (ECM). Follow the Service Instruction outlined below.



Labour Time:
Operation Description Operation No. Time
Re-configure the Engine Control Module 12.90.13 0.4 hours

Repair/Claim Coding:
Causal Part: RCFG
ACES Condition Code: 42
Defect Code:


Service Instruction
1 . CAUTION: This procedure requires IDS DVD108 Patch File 6 software or later.

Connect a Midtronic battery conditioner/power supply to the vehicle.
2 . Connect IDS to the vehicle and begin a new diagnostic session, by entering the correct VIN for the current vehicle.
3 . When prompted 'Do you wish to read diagnostic trouble codes?', select 'Yes' and then press 'tick' to continue.
4 . Clear diagnostic trouble code.
5 . Follow all on-screen instructions to complete this task.
6 . Select 'Vehicle Configuration' then 'Module Programming'. From the menu select 'Configure Existing Modules'.
7 . Select and run 'Engine Control Module (ECM)'.
8 . Follow all on-screen instructions to complete this task.
9 . When the task is completed, exit the current session.
10 . Disconnect IDS and the battery charger/power supply.
"

R/Charvis New one is not the better one!

Hello Charvis, I am truly unhappy with your experience. I do not know what prevents you to look at the right publication, and my help comes to an end. If I have understood correctly, Albert and Dave have successfully found the techn. bulletins following my description. Please try again, you must hit the right bulletin for presentation to your dealer.

Good luck and best regards
YF

YF,

We found the right stuff after a bit of searching, but I notice that if we (or I) want to read the full documentation then we have to pay for it. I would have thought that this info would be freely available to all.

I guess not all things in life are free.........................  ______________________
2011 Full Fat RR 4.4 TDV8
2012 FL2 SD4 Auto HSE
2013 Kawasaki Versys 650

Dear YF,

Thank you for your kindly reply so much! I did not mean to let you have any unhappy experience.

Dear Abbert/Dave,

Have you found the right techn. bulletin related sensor replacement?

R/Charvis  New one is not the better one!