please can any one help, I need to the torque setting for the 6mm alen key bolt which goes through the clamp which clamps the injector down. (my08 freelander 2 2.2td4) thanks

From the book

Make sure that the component is clean, free of foreign material and lubricant.
Make sure that a new sealing washer is installed.
Install the fuel injector.
Torque:
Stage 1:5 Nm Stage 2:130°
2. 2. CAUTION: Make sure that the component is clean, free of foreign material and lubricant.
Install a new high-pressure fuel supply line but do not fully tighten at this stage.
Tighten the high-pressure fuel supply line.
Torque:
Stage 1:22 Nm Stage 2:25 Nm
3. Attach the spill return line and secure with the keeper.
4. Install the engine cover.
5. 5. CAUTION: Bleed the fuel system by cranking the engine to purge the air from the system.
Bleed the fuel system.
6. If a new component has been installed, configure using Land Rover approved diagnostic equipment. p****d off with a Digital Keyboard Warrior

The Topix manual I have says for the TD4 injector clamp bolt:

Stage 1 = 5 NM

Stage 2 = 130°

Hope that helps. FL2 HSE Auto Galway Green
Evoque SD4 Auto Blue.
FL1 HSE TD4 Manual Black - Gone.
RR Classic V8 EFI - Gone

Two the same, can't be bad. p****d off with a Digital Keyboard Warrior

thanks for that guys really big help!