Aye good point in removing them if going off road. Hhhhmmmm dunno, I will have to see one with them fitted I think

Ok, just got mine delivered from Landy but how do I fit them. Got two moulings and 8 screws. Do I just screw into the plastic to hold in place? And what do I do with the sticking out tube bit. cut it off?

wizking wrote:

Ok, just got mine delivered from Landy but how do I fit them. Got two moulings and 8 screws. Do I just screw into the plastic to hold in place? And what do I do with the sticking out tube bit. cut it off?

Hello!

I personally drilled a hole for the lug in my bumper.... wasn't too bad! (its there for a reason after all!)

We drilled a small 1mm hold through the lug and on to the bumper to get the perfect positioning.



then drilled out with an 8mm drill bit.



then drilled a small pilot hole for the extra screw on the end and put in black self tappers.

hope this helps!

:thumbsup:

Admin note: this post has had its images recovered from a money grabbing photo hosting site and reinstated  

Yes, very helpful thanks. Did you have to remove screws first as there isn't anything in my bumper screw holes?

wizking wrote:

Yes, very helpful thanks. Did you have to remove screws first as there isn't anything in my bumper screw holes?

should be 2 original fixing in each side ? I just unscrewed these then screwed it back in with the spat attached? 

ok, thanks. Looks like the dealers forgot to put these screws back in then after it went in for the parking sensors.

wizking wrote:

ok, thanks. Looks like the dealers forgot to put these screws back in then after it went in for the parking sensors.

they hold the bumper to the wheel cowling so quite crucial.... 

just taken a pic of how it should look ->



Admin note: this post has had its images recovered from a money grabbing photo hosting site and reinstated  

Thanks again Stownrow.

All fitted and looking good. I had all four screws missing and the wheel cowling was loose both sides.. Thanks again stownrow.