Hi All

I have diagnosed a worn clutch master cylinder on my face lift FL2. Is the procedure for removal different on the pre face lift model. I have the LR service manual for 2010 model and the Haynes manual. Its a bit congested in the foot well. I can only find one bolt. I am attempting to change the master cylinder and HP pipe work. Have replaced the clutch/pressure plate/ slave cylinder/ DMF with LR parts. The existing HP pipe work has a defective joint at the master cylinder. The pipe just pulls out!! leaving the connector in place. Not good.

If this subject has been covered in another post can someone direct me to it.

Any help here would be appreciated.

Thanks