We had a callout today.

Freelander cranks but doesn't start. Starter motor was replaced about a week ago by others. 'others' also tell me they had a suspension sensor error (¿¿¿¿ ???) could not reproduce that. Well I cleared about 18 errors, most of them totally irrelevant and old.

IIdtool says it has amongst others B10A2 stuck. that is the only one I can't erase, it pops back immediately.

Rocking the car , pushing in back and forward finally allowed to start it

There is also a fuel pressure high error, which I could clear. The rail pressure and low pressure sensor indicate the same, which indeed was around 150 KPA so I am not believing it and yes, that was justified.

But how do we get rid off the erratic crash error?

Somebody must have lived it, the closest I got was in Lady Jane's post about a defective starter and this causing the error.

I read on this forum somebody found a relay for the crash sensor, I could not find any evidence in the wiring diagrams though


Would be grateful for any feedback

PS , yes it is a petrol engine and quite exotic, even here