westville wrote:

westville wrote:

I bought these http://www.ebay.co.uk/itm/321754914031?_tr...EBIDX%3AIT
Excellent quality

I'm pretty sure they are from the same source as OEM as they have the LR EGG logo ( blanked out) moulded into them
Well worth the money and fitted straight on as per the video mentioned above

The LR logo blanked out, they are probably seconds, not quite up to the mark, may have slight moulding flow marks in them, could be as little as that?

Or more likely, the Land Rover product has been copied as closely as possible without actually committing any trademark infringement.

Another 'thank you' everyone. I'm ordering a set of these too

Wow a double set, your FL2 will certainly be well protected no doubt about that, sort of like the first set are sacrificial to protect the genuine expensive ones behind them?

Now that's an idea
Is there a fitting guide on YouTube?  No Longer the owner of a 2013MY Fuji White GS

"Fiat Lux" a philosophy not a car

Ok, so I ordered the front mudflaps from PowerfulUK, and to my surprise they fit snugly.

To my surprise once again, they are quite a flexible rubber like material, and are not brittle at all.

I reckon they all source them from the same factory  No Longer the owner of a 2013MY Fuji White GS

"Fiat Lux" a philosophy not a car

As mentioned before, these mudflaps indeed appear to have the Land Rover oval on the inside that has had the marque clearly erased..

Mine were delivered in a new purpose made cardboard package with each flap individually wrapped in a bubble envelope - just smacked of quality and as I said before they bear the same mould markings (crisp and clear) with no moulding errors or flaws.
You decide which is best value for money  No Longer the owner of a 2013MY Fuji White GS

"Fiat Lux" a philosophy not a car

Same here, each flap was well packaged in a massive divided box in protective packaging with the correct metal bracket paired with the correct flap in each part.

I have to say I fitted mine successfully, but decided not to cut the bottom of the side moulding as per video, because I felt there was no real need. So I drilled two holes, and cut out the little slots at the side to allow for the screw holes. All on looking nice and flush, and sturdy.

Thanks for the advice, I'm glad I went for them. I see no reason to doubt the quality.

Here we are. Here is the fitted article:



Side steps going on next!