Forum-Gallery-Shop-Sponsors

« Advertise on Freel2.com

Home > Maintenance & Modifications > warning light instrument cluster
Post Reply  Down to end
Page 1 of 2 12>
Print this entire topic · 
nakul



Member Since: 07 Mar 2012
Location: new delhi
Posts: 1

India 2011 Freelander 2 TD4 SE Auto Fuji White
warning light instrument cluster

My 2011 fl2 has clocked 20000km

Ive noticed a red warning light ( "!" in a circle) flashed a couple of times in a day.

Need help

Post #135131 7th Mar 2012 7:56 pm
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
EYorkshire



Member Since: 18 Nov 2010
Location: (!)
Posts: 4392

Looks like a warning for the brake system

Post #135135 7th Mar 2012 8:22 pm
View user's profile Send private message View poster's gallery Reply with quote
bigalf1961



Member Since: 14 Mar 2011
Location: manchester
Posts: 846

United Kingdom 2011 Freelander 2 TD4_e XS Manual Lago Grey

hand brake warning light? need more info where light is located in the instrument cluster :!:first check the brake fluid level in the reservoir in the engine bay under the bulkhead panel right hand side or vehicle Idea rainy-city
xs

Post #135136 7th Mar 2012 8:24 pm
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
EYorkshire



Member Since: 18 Nov 2010
Location: (!)
Posts: 4392

Is it this Question



If so it comes on momentarily on start up for a bulb check, not sure but may come on with handbrake operated and if its not the handbrake switch then its a fault with the brake system.

Post #135137 7th Mar 2012 8:37 pm
View user's profile Send private message View poster's gallery Reply with quote
athelstan



Member Since: 03 Nov 2009
Location: Reality
Posts: 2658

nakul
If you lightly press the "Start/Stop" ignition button for a second it will illuminate your instrument panel for a few approximately 4 seconds whilst the FL2 checks its systems/functions and then if all's fine with your FL2 all the warning lights will go off. During this short test period you will see the following:

The symbol EYorkshire has shown you is located below the engine temperature gauge, a red circle with an exclamation "!" mark in the centre. If this remains ON whilst the engine is operating then you have either:

a) a fault with the Emergency Brake Assist - a device that boosts the the braking force when the driver rapidly applies the brakes in an emergency situation, or,

b) a fault with the Electronic Brake Distribution system - this controls the balance of the braking between the front and rear wheels to maintain the FL2's maximum braking efficiency. If the FL2 is fully loaded with passengers and/or heavy items in the load space then the braking force is distributed in favour of the rear wheels. If their is only the driver in the vehicle i.e. "lightly loaded" then the braking force is reduced on the rear wheels.

Should this red warning light remain on all the time when driving you should report the fault to your LR dealer as soon as possible.

Finally, there is another brake related red symbol - this is the Hand Brake Warning light and this is located in top half of the speedometer in the 1 o'clock position. It is a red circle with a "P" in the middle. This alerts the driver to the fact that the handbrake is still engaged. Release the handbrake and the red light will go off, if it remains on whilst driving you should a) take the hand brake off, and if that fails to extinguish the warning light then b) report the fault as soon as possible to your LR dealer.

Post #135159 8th Mar 2012 8:15 am
View user's profile Send private message View poster's gallery Reply with quote
theox2003



Member Since: 18 Jul 2014
Location: London
Posts: 45

United Kingdom 

Hi all!
Can anyone shed any light on the following....the wife was driving and noticed a light within the instrument cluster. Took a photo which I've uploaded. Ends up being the engine light.
Cheers


This post has been edited by the site administration team - added picture

Post #232822 26th Aug 2014 6:46 pm
View user's profile Send private message View poster's gallery Reply with quote
dunkley201



Member Since: 09 Jul 2011
Location: Lincolnshire
Posts: 2739

United Kingdom 2010 Freelander 2 TD4 HSE Auto Stornoway Grey

You don't say what model you have - Diesel or i6? The handbook says:

"Check engine - petrol models only".

"Illuminates amber in the instrument pack as a bulb and system check when the starter switch is turned on and extinguishes as soon as the engine has started. Illumination at any other time indicates that the emission performance of the engine management system is impaired - seek qualified assistance. If the indicator flashes while driving, immediately reduce engine power to avoid catalytic converter damage."

Bob 10MY (Sept 09) TD4 HSE Auto in Stornoway Grey (Now Gone)

08 FL2 TD4 SE Manual in Rimini Red (Now Gone)

Post #232826 26th Aug 2014 6:58 pm
View user's profile Send private message View poster's gallery Reply with quote
theox2003



Member Since: 18 Jul 2014
Location: London
Posts: 45

United Kingdom 

Schoolboy error sorry 2.2 HSE Diesel.
Update - no loss of power
Also, what about driving conditions? Yestersdays weather was bad so roads were extremely wet, puddles galore. The wife mentioned that conditions were the same when she went visiting.
Cheers

Morning - can anyone shed any light to the above regarding the Engine Warning Light?
Thanks


Last edited by theox2003 on 26th Aug 2014 8:12 pm. Edited 1 time in total

Post #232830 26th Aug 2014 7:11 pm
View user's profile Send private message View poster's gallery Reply with quote
theox2003



Member Since: 18 Jul 2014
Location: London
Posts: 45

United Kingdom 

Hi, just ran diagnostics and fault code came back P0299.
The trouble code P0299 (turbo under boost) has set off the check engine light.
Any suggestions? Can I fix it?
2.2 HSE

Post #233115 29th Aug 2014 5:50 pm
View user's profile Send private message View poster's gallery Reply with quote
ad210358



Member Since: 12 Oct 2008
Location: Here and There
Posts: 7464

England 

Check the Turbo Pipes, could have a loose Jubilee Clip or even a split, also look for traces of oil on the pipes, another sign of a leak. Thumbs Up

Post #233118 29th Aug 2014 6:06 pm
View user's profile Send private message View poster's gallery Reply with quote
theox2003



Member Since: 18 Jul 2014
Location: London
Posts: 45

United Kingdom 

Nice one ad210358 will take a look tomorrow morning.

Post #233150 29th Aug 2014 9:55 pm
View user's profile Send private message View poster's gallery Reply with quote
theox2003



Member Since: 18 Jul 2014
Location: London
Posts: 45

United Kingdom 

Hi, found the cracked turbo inlet pipe so had to tape it up until the replacement arrives. Noticed tonight a real noise when accelerating through the gears. It sounds like hearing sky rockets being let off. I've recorded the sounds if someone is able to shed any light on this matter.
Thanks

Post #233225 30th Aug 2014 9:30 pm
View user's profile Send private message View poster's gallery Reply with quote
oldgeezer



Member Since: 09 Apr 2011
Location: Wiltshire
Posts: 1302

United Kingdom 2013 Freelander 2 TD4 GS Manual Baltic Blue

That will be an air leak from a pipe causing the shriek ! And will trigger your engine fault code of under boost. Have a look around your pipes for evidence of an oily mist trace . Jaguar x-type sport gone
Jaguar x-type 2.2d sport one of my best cars ever sadly gone
Freelander 2 GS auto 2008 most unreliable ever ! gladly gone
Freelander 2 GS manual 2013 only time will tell !

Post #233267 31st Aug 2014 8:32 am
View user's profile Send private message View poster's gallery Reply with quote
theox2003



Member Since: 18 Jul 2014
Location: London
Posts: 45

United Kingdom 

Cheers for the feedback as always its much appreciated. As previously mentioned that I did find the crack in the rubber pipe so unclipped it and taped it up. This intercooler turpo hosing will be replaced when it arrives but I still get this high screatching when accelerating through the gears.
Is this due to the air intake from this pipe?
It drives fine but this noise is a real concern as the wife is 1 day overdue:-)
Cheers

Post #233305 31st Aug 2014 11:56 am
View user's profile Send private message View poster's gallery Reply with quote
ad210358



Member Since: 12 Oct 2008
Location: Here and There
Posts: 7464

England 

Has the noise appeared since you've taped up the pipe, if so it could be the air blowing through the joins in the tape, akin to blowing through a reed Question
There is a lot of pressure on these pipes, when under no pressure you can squeeze them to being rock hard under load.

Post #233311 31st Aug 2014 12:20 pm
View user's profile Send private message View poster's gallery Reply with quote
Post Reply  Back to top
Page 1 of 2 12>
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
Freel2.com RSS Feed - All Forums


Switch to Mobile site