Forum-Gallery-Shop-Sponsors

« Advertise on Freel2.com

Home > Maintenance & Modifications > A Haldex Question
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
JST



Member Since: 01 Nov 2011
Location: Lizant
Posts: 1098

France 2007 Freelander 2 TD4 HSE Manual Narvik Black
A Haldex Question

At 52,000 miles my 07 succumbed to the dreaded diff bearing issue. So yesterday I fitted a recon diff. The only issue I had was when it came time to refill the Haldex. I followed the prescribed procedure finishing up with the removal of 70ml of oil. After all this I had in fact added a total of 570ml of oil. The book says the capacity is 650ml. Would I be right in assuming that the pump and internal oilways of the Haldex would account for the "missing" 80ml which didn't drain out? Come to think of it I am sure I didn't get 650ml out when I drained it.

As an aside, I took photos as I did the diff job and may post a report should anyone be interested in the DIY angle. John
07 HSE Narvick Black
Land Rover Series One
Triumph Rocket 111 (sadly gone!)

Post #217137 17th Feb 2014 8:19 am
View user's profile Send private message View poster's gallery Reply with quote
j00ppis



Member Since: 24 May 2013
Location: Finland
Posts: 198

Finland 

When i changed my rear diff to reconditioned, i filled it toplevel both diff oil and haldex oil until if runs oil from filling hole, then i put the plug and installed differential, dont know is this right way but i think this works! Very Happy not sure if it brokes something? somebody ideas?

Post #217145 17th Feb 2014 9:55 am
View user's profile Send private message View poster's gallery Reply with quote
JST



Member Since: 01 Nov 2011
Location: Lizant
Posts: 1098

France 2007 Freelander 2 TD4 HSE Manual Narvik Black

To fill the Haldex you are supposed to fill it until oil runs from the filler plug, switch on the ignition and wait 5 minutes, top up the Haldex until the oil runs out the filler hole again and then remove exactly 70ml of oil. I don't know what the significance of taking out the 70ml of oil is. Perhaps a high oil level may let oil seep through the seal to the diff or maybe it can affect the pump. Anyone know? John
07 HSE Narvick Black
Land Rover Series One
Triumph Rocket 111 (sadly gone!)

Post #217149 17th Feb 2014 10:11 am
View user's profile Send private message View poster's gallery Reply with quote
j00ppis



Member Since: 24 May 2013
Location: Finland
Posts: 198

Finland 

ive had few problems after installing diff. There was tiny hole in center of diff, bottom of it. Tiny washer arounding and center of it tiny hole which leaked somekind of oil and when inspected it it was diff oil, sticky. Then i tryed to stop it whit chemical methallic padding whit out succes, until the leak suddently stopped Surprised, no idea but now i think its fine and i have checked both haldex and diff plug and there is oil so i dont think i have to worrie about =)? no one could tell me about the hole, somebody told that its somekind of tell tell hole of bearing seal failure, and someone told that there should not be anykind of hole bottom of it Very Happy

check this http://www.freel2.com/forum/topic16071.html

Post #217153 17th Feb 2014 10:21 am
View user's profile Send private message View poster's gallery Reply with quote
JST



Member Since: 01 Nov 2011
Location: Lizant
Posts: 1098

France 2007 Freelander 2 TD4 HSE Manual Narvik Black

The hole should be there. If you had a leak which went away, my guess is the new seal bedded in a bit after a while and stopped leaking. Or you have no diff oil left! Very Happy John
07 HSE Narvick Black
Land Rover Series One
Triumph Rocket 111 (sadly gone!)

Post #217159 17th Feb 2014 10:40 am
View user's profile Send private message View poster's gallery Reply with quote
j00ppis



Member Since: 24 May 2013
Location: Finland
Posts: 198

Finland 

Can you tell me why in my orginal diff didnt have any hole =)? it was orginal!?

Post #217161 17th Feb 2014 10:46 am
View user's profile Send private message View poster's gallery Reply with quote
JST



Member Since: 01 Nov 2011
Location: Lizant
Posts: 1098

France 2007 Freelander 2 TD4 HSE Manual Narvik Black

A mystery! Mine is an older FL2 and has the hole. John
07 HSE Narvick Black
Land Rover Series One
Triumph Rocket 111 (sadly gone!)

Post #217163 17th Feb 2014 10:48 am
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
Freel2.com RSS Feed - All Forums


Switch to Mobile site