Forum-Gallery-Shop-Sponsors

« Advertise on Freel2.com

Home > Technical > Sticking throttle flap possibly? Just fires then stops
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
The dog



Member Since: 03 Oct 2016
Location: Aberdeenshire
Posts: 62

Scotland 
Sticking throttle flap possibly? Just fires then stops

Freelander 2.2 diesel was running great but then refused to start and continue running, it does fire for a second or so then dies. Fuel rail pressure is good and no trouble codes are showing.
I'm totally convinced this is not a fuel problem as the fuel filter is new and the system definitely has no air locks and the car has ran for a good 40+ miles since the filter was replaced. The car ran great was parked-up and then refused to start it just fires and stops
Could this be a case of the throttle flap not opening on start up and strangling the engine of air. I can't hear the flap slapping closed on switching off the ignition. Puzzled Question The Dog

Post #332267 2nd Oct 2017 9:25 pm
View user's profile Send private message View poster's gallery Reply with quote
Andy131



Member Since: 09 Dec 2009
Location: Manchester
Posts: 2183

United Kingdom 

In short yes

Mine died outside the mother-in-laws late one night.
Would start, but couldn't reach tickover speed, then died - it does depend at what angle the flap jams.
The nice man from the AA said how rough would you allow me to be - I pointed out that it was either fixed or I had to stay at the mother-in-laws. Litterally 10 minutes later, he rammed a screwdriver through the offending throttle flap.
Job done, we went home, lasted until I replaced the throttle body next weekend. Tangiers Orange - gone, missing her
Replaced by Ewok what a mistake - now a happy Disco Sport owner

Post #332558 5th Oct 2017 5:16 pm
View user's profile Send private message View poster's gallery Reply with quote
The dog



Member Since: 03 Oct 2016
Location: Aberdeenshire
Posts: 62

Scotland 

Thanks Andy I'll take a look at the throttle flap tomorrow. No mother-in-law stay over threats on me though Laughing

Post #332577 5th Oct 2017 9:04 pm
View user's profile Send private message View poster's gallery Reply with quote
The dog



Member Since: 03 Oct 2016
Location: Aberdeenshire
Posts: 62

Scotland 

Well I removed the throttle valve assembly but left it plugged-in electrically, switched on and off the ignition the throttle flap operated as it should. I tried to start the engine with the throttle valve assembly removed from the manifold, it started for a few turns and then cut out exactly as before. Still no fault codes showing. Crank sensor renewed again just as a matter of course. Now I'm Totally flummoxed! Could the crank trigger ring be playing up again? The Autel Maxi Diag has ran out of ideas Big Cry The Dog

Post #332660 6th Oct 2017 8:25 pm
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
Freel2.com RSS Feed - All Forums


Switch to Mobile site