Hi

After a small incident I have just replaced the front bumper on our freelander 2 S spec
I have bought one with fog lights installed where the original didn't have them
There was a blanked off connector on the passenger side mudguard which fitted into the harness that came with the replacement bumper .

I have also obtained a lighting switch from an xs spec which has the additional fog light switch for the front

unfortunately the fog lights do not work when the switch is pressed, I assume the software needs to be updated

I have an LR SDD diagnostic setup so can change options etc but i can't find where in the sdd to add the fogs in.

Anybody any ideas

Cheers