I am getting rear pads changed at upcoming service currently @ 32k miles. Was mentioned they were getting low at MOT and expected as was told at last years service they should be good for approx 10k.

From what I can gather the fronts are much thicker and from a few posts I could find they seem to last 10K longer than rears before needing replacement. Is this what others are finding?

Also trying to gauge how often others are having discs changed, i.e. every second pad change?

Hoping not to get a shock when it's in being serviced.

I did 88000 miles before I sold my last one and still didnt need any pads front or rear.
Then i know someone who can wear a set out in 10000 miles, so depends how you drive.

First service at 12.5k showed 10% wear Td4 XS manual, Orkney Grey, MY2014

All depends on the type of driving and your style of driving. Long motorway trips and they will only be used at the end of the motorway. Short, around town trips and you'll be using them at every road junction. Fronts will always wear out quicker than rears as you do 80% of your braking on the front.

Had front and back changed when my car was serviced last year at 40000 miles. I do mostly town driving. Black MY2013 SD4 GS Auto, Wood Company Armrest, Freel2 sticker.
Gone MY2010 Freelander 2 Manual TD4.e S, Alaska White.

Steve D wrote:

Fronts will always wear out quicker than rears as you do 80% of your braking on the front.

Also correct on every car on the planet. You must have a very special FL2.

Me and all the others on here that have experienced the same with their FL2 - suggest you use the search function. FL2 HSE Auto Galway Green
Evoque SD4 Auto Blue.
FL1 HSE TD4 Manual Black - Gone.
RR Classic V8 EFI - Gone

Yeah, what would I know - I've only been a mechanic for 40 years.

My rear pads and discs also wore out faster... Second set of discs and pads on rear, originals on front.
About 48k miles now. Rears changed at about 43k miles.

Steve D wrote:

Also correct on every car on the planet. You must have a very special FL2.

Steve D wrote:

Yeah, what would I know - I've only been a mechanic for 40 years.

Perhaps that's my problem then - I'm too old school for all this modern stuff! I was taught that only heavily laden commercial vehicles with load sensing valves suffered excessive rear brake wear. From personal experience, my ratio of changing brakes and discs on the vehicles I work on are probably around 10:1 in favour of fronts. On my own FL that I've had just over two years, fitting discs and pads all round almost from when I first got it, I'd say the fronts have worn around 30% and the rears probably less than 10%. Know this because I've had a long term problem with squeaking and have had them out about half a dozen times for relubing. Rather embarrassingly, it turned out to be the rears that were squeaking, not the front - my wife noticed where the squeak was coming from - I must be going deaf as well as daft!

Ill chip in too. Had rear pads replaced as they were 100% worn (!!) but fronts still fine and original at 38k. FL2 TD4 GS 60 reg Facelift - so many issues
2019 DS. Terribly unreliable.
Sold DS for a 2021 Mitsubishi Outlander PHEV. Fingers crossed....
Sold Outlander for a 2014 SD4 SE Tech because I’m mental
Now greatly regret selling the Outlander. MPG of the FL2 is atrocious and so are the fuel bills. Fun though 😎
Couldn’t afford the fuel bills so back to an older Mitsubishi Outlander PHEV. Significantly better than I remembered it to be…

Steve D wrote:

......I'd say the fronts have worn around 30% and the rears probably less than 10%.....
it turned out to be the rears that were squeaking, not the front..........

Well, they were both the same make - Mintex- and they could have been different materials but I eventually cured it - see my last post here. Ooh I could have kicked myself!

http://www.freel2.com/forum/topic15628.html