After searching for months for a proper roofrack for my Freelander, I decided to go with a custom made solution. As I don't think I'll need a full roofrack, we went the easy way and manufactured one only for the back of the car. You can see below what came out.













Few comments:
- overall, it is very solid and very good quality
- the wind deflector details are not as good as they should be, so this will probably be replaced. Now it's made from plastic, it will be made from fiber glass most likely.
- it weights about 20kg but it will support over 100 with no problem.
- in case a full version is needed, it is not complicated to extend it.
- no wind noise at all. At 130km/h, with music turned off, I couldn't hear it!
- the price was very decent, about 200 EUR.

P.S. Pictures don't serve it well, they were made with my phone camera....

Good skills

yer looks pretty good although a bit on the small side but hay if it works for you then no probs

The length was adjusted so that it fits those holding places which are already installed on the roof, as I didn't want to drill any holes. I don't know if there are any other mounting points along the roof...

There are mounting points just above the front top corner of the front doors, just before the start of the windscreen.

On mine there is a shorter peice of plastic strip with a cross marked on it - if I remember correctly  2002 Honda VFR800
2002 Toyota Celica 140 Silver (mid life crisis - again!)
2007 FL2 GS Manual Army Reconnaissance Green + freel2.com sticker
2004 Toyota Celica 140 Black - Gone
2000 Toyota Celica 140 Silver - Gone
1998 Toyota Celica ST Pearl Green - Gone
1996 Nissan Primera 1.6 - Gone
1994 Rover Montego 1.6 Auto - Gone

Engineering respect

Tidy job

Spot the magmount on the roof  ______________________
2011 Full Fat RR 4.4 TDV8
2012 FL2 SD4 Auto HSE
2013 Kawasaki Versys 650

I fitted the LR rails on my old FL2 and yes the trim has to be drilled on the cross to use the mounts. The main reason why I left the rails on when I traded in.

I use a full basket bolted directly on to a pair of aftermarket bars I had for the FL1. However being so large it is very easy to get to the 75Kg limit. Prog rock is cool!
2012 XS SD4 Indus Silver